We synthesized cationic random amphiphilic copolymers by radical copolymerization of methacrylate monomers with cationic or hydrophobic groups and evaluated their antimicrobial and hemolytic activities. The nature of the hydrophobic groups, and polymer composition and length were systematically varied to investigate how structural parameters affect polymer activity. This allowed us to obtain the optimal composition of polymers suitable to act as non-toxic antimicrobials as well as non-selective polymeric biocides. The antimicrobial activity depends sigmoidally on the mole fraction of hydrophobic groups (fHB). The hemolytic activity increases as fHB increases and levels off at high values of fHB, especially for the high-molecular-weight polymers. Plots of HC50 values versus the number of hydrophobic side chains in a polymer chain for each polymer series showed a good correlation and linear relationship in the log–log plots. We also developed a theoretical model to analyze the hemolytic activity of polymers and demonstrated that the hemolytic activity can be described as a balance of membrane binding of polymers through partitioning of hydrophobic side chains into lipid layers and the hydrophobic collapsing of polymer chains. The study on the membrane binding of dye-labeled polymers to large, unilamellar vesicles showed that the hydrophobicity of polymers enhances their binding to lipid bilayers and induces collapse of the polymer chain in solution, reducing the apparent affinity of polymers for the membranes.
A variety of methods exist for the design or selection of antibodies and other proteins that recognize the water-soluble regions of proteins; however, companion methods for targeting transmembrane (TM) regions are not available. Here, we describe a method for the computational design of peptides that target TM helices in a sequence-specific manner. To illustrate the method, peptides were designed that specifically recognize the TM helices of two closely related integrins (alphaIIbbeta3 and alphavbeta3) in micelles, bacterial membranes, and mammalian cells. These data show that sequence-specific recognition of helices in TM proteins can be achieved through optimization of the geometric complementarity of the target-host complex.
We report the structure-activity relationship in the antimicrobial activity of linear and branched poly(ethylene imine)s (L- and B-PEIs) with a range of molecular weights (MWs) (500–12,000). Both L- and B-PEIs displayed enhanced activity against Staphylococcus aureus over Escherichia coli. Both B- and L-PEIs did not cause any significant permeabilization of E. coli cytoplasmic membrane. L-PEIs induced depolarization of S. aureus membrane although B-PEIs did not. The low MW B-PEIs caused little or no hemolysis while L-PEIs are hemolytic. The low MW B-PEIs are less cytotoxic to human HEp-2 cells than other PEIs. However, they induced significant cell viability reduction after 24 hours incubation. The results presented here highlight the interplay between polymer size and structure on activity.
A novel fluorescence method for determining the depth of Trp residues in membrane-inserted polypeptides is introduced. Quenching of Trp by acrylamide and 10-doxylnonadecane (10-DN) was used to measure Trp depth. Transmembrane helices with Trp residues at varying positions (and thus locating at different depths in lipid bilayers) were used to calibrate the method. It was found that acrylamide quenches Trp close to the bilayer surface more strongly than it quenches deeply buried Trp, while 10-DN quenches Trp close to the center of the bilayer more strongly than Trp close to the surface. The ratio of acrylamide quenching to that of 10-DN was found to be nearly linearly dependent on the depth of Trp in a membrane. It was also found that it was possible to detect coexisting shallowly and deeply inserted populations of Trp-containing polypeptides using these quenchers. In the presence of such mixed populations, acrylamide induced large blue shifts in fluorescence emission lambda(max) whereas 10-DN induced large red shifts. In a more homogeneous population quencher-induced shifts were found to be minimal. Dual quencher analysis can be used to distinguish hydrophobic helices with a transmembrane orientation from those located close to the bilayer surface and, when applied to a number of different peptides, revealed novel aspects of hydrophobic helix behavior.
Antibiotic-resistant bacteria 'superbugs' are an emerging threat to public health due to the decrease in effective antibiotics as well as the slowed pace of development of new antibiotics to replace those that become ineffective. The need for new antimicrobial agents is a well-documented issue relating to world health. Tremendous efforts have been given to developing compounds that not only show high efficacy, but also those that are less susceptible to resistance development in the bacteria. However, the development of newer, stronger antibiotics which can overcome these acquired resistances is still a scientific challenge because a new mode of antimicrobial action is likely required. To that end, amphiphilic, cationic polymers have emerged as a promising candidate for further development as an antimicrobial agent with decreased potential for resistance development. These polymers are designed to mimic naturally occurring host-defense antimicrobial peptides which act on bacterial cell walls or membranes. Antimicrobial-peptide mimetic polymers display antibacterial activity against a broad spectrum of bacteria including drug-resistant strains and are less susceptible to resistance development in bacteria. These polymers also showed selective activity to bacteria over mammalian cells. Antimicrobial polymers provide a new molecular framework for chemical modification and adaptation to tune their biological functions. The peptide-mimetic design of antimicrobial polymers will be versatile, generating a new generation of antibiotics toward implementation of polymers in biomedical applications.
The M2 protein from influenza A is a pH-activated proton channel that plays an essential role in the viral life cycle and serves as a drug target. Using spin labeling EPR spectroscopy we studied a 38-residue M2 peptide spanning the transmembrane region and its C-terminal extension. We obtained residue-specific environmental parameters under both high and low pH conditions for nine consecutive C-terminal sites. The region forms a membrane surface helix at both high and low pH although the arrangement of the monomers within the tetramer changes with pH. Both electrophysiology and EPR data point to a critical role for residue Lys 49.M2 is a 96-residue homotetrameric integral membrane protein with a small N-terminal ectodomain, a single transmembrane helix and a C-terminal cytoplasmic tail. Despite data from solid state NMR (1), x-ray crystallography (2) and solution NMR (3), a detailed understanding of how the M2 protein works continues to puzzle investigators and generate sharp controversy.The majority of published studies on the proton channel function of M2 have focused on the transmembrane (TM) 1 domain. However, truncation studies indicate that the cytoplasmic domain also plays a role in channel stability (4). Proteolysis of micelle-bound full length M2 revealed that a 15-20 residue segment C-terminal to the TM helix was highly protected from cleavage by proteases (5). Helical wheel analysis of the protected region (5) suggested that the segment could form an amphiphilic helix, consistent with later findings from solid state NMR on M2 protein in lipid bilayers (6). In order to further test the proposed models, we probed the conformation of the segment C-terminal to the TM domain at both high and low pH using sitedirected spin-labeling (SDSL) and electron paramagnetic resonance (EPR) spectroscopy.EPR studies were performed on a series of 38-residue synthetic M2 peptides (residues 23-60; M2TMC) spanning the TM region and the beginning of the C-terminal domain. We spin- † This research was supported by R01AI57363 (LHP), GM56423 (WFD), a Henry Dreyfus Teacher Scholar Award (KPH) and R15AI074033 (KPH).
The effects of amino acid substitutions upon the behavior of poly(Leu)-rich alpha-helices inserted into model membrane vesicles were investigated. One or two consecutive Leu residues in the hydrophobic core of the helix were substituted with A, F, G, S, D, K, H, P, GG, SS, PG, PP, KK, or DD residues. A Trp placed at the center of the sequence allowed assessment of peptide behavior via fluorescence emission lambda(max) and dual quenching analysis of Trp depth [Caputo, G. A., and London, E. (2003) Biochemistry 42, 3265-3274]. In vesicles composed of dioleoylphosphatidylcholine (DOPC), all of the peptides with single substitutions adopted a transmembrane (TM) state. Experiments were also performed in thicker bilayers composed of dierucoylphosphatidylcholine (DEuPC). In DEuPC vesicles TM states were destabilized by mismatch between helix length and bilayer thickness. Nevertheless, in DEuPC vesicles TM states were still prevalent for peptides with single substitutions, although less so for peptides with P, K, H, or D substitutions. In contrast to single substitutions, certain consecutive double substitutions strongly interfered with formation of TM states. In both DOPC and DEuPC vesicles DD and KK substitutions abolished the normal TM state, but GG and SS substitutions had little effect. In even wider bilayers, a SS substitution reduced the formation of a TM state. A peptide with a PP substitution maintained the TM state in DOPC vesicles, but in DEuPC vesicles the level of formation of the TM state was significantly reduced. Upon disruption of normal TM insertion peptides moved close to the bilayer surface, with the exception of the KK-substituted peptide in DOPC vesicles, which formed a truncated TM segment. These studies begin to provide a detailed relationship between sequence and the stability of TM insertion and show that the influence of insertion-destabilizing residues upon hydrophobic helices can be strongly modulated by properties such as mismatch. For certain helix-forming hydrophobic sequences, sensitivity to lipid structure may be sufficient to induce large conformational changes in vivo.
Synthetic polymers have been used as a molecular platform to develop host-defense antimicrobial peptide (AMP) mimetics which are effective in killing drug-resistant bacteria. In this topical review, we will discuss the AMP-mimetic design and chemical optimization strategies as well as the biological and biophysical implications of AMP mimicry by synthetic polymers. Traditionally, synthetic polymers have been used as a chemical means to replicate the chemical functionalities and physicochemical properties of AMPs (e.g., cationic charge, hydrophobicity) to recapitulate their mode of action. However, we propose a new perception that AMP-mimetic polymers are an inherently bioactive platform as whole molecules, which mimic more than the side chain functionalities of AMPs. The tunable nature and chemical simplicity of synthetic random polymers facilitate the development of potent, cost-effective, broad-spectrum antimicrobials. The polymer-based approach offers the potential for many antimicrobial applications to be used directly in solution or attached to surfaces to fight against drug-resistant bacteria.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.