The electrical properties of polymer nanocomposites containing a small amount of carbon nanotube (CNT) are remarkably superior to those of conventional electronic composites. Based on three-dimensional (3D) statistical percolation and 3D resistor network modeling, the electrical properties of CNT nanocomposites, at and after percolation, were successfully predicted in this work. The numerical analysis was also extended to investigate the effects of the aspect ratio, the electrical conductivity, the aggregation and the shape of CNTs on the electrical properties of the nanocomposites. A simple empirical model was also established based on present numerical simulations to predict the electrical conductivity in several electronic composites with various fillers. This investigation further highlighted the importance of theoretical and numerical analyses in the exploration of basic physical phenomena, such as percolation and conductivity in novel nanocomposites.

Engineering ceramics have high stiffness, excellent thermostability, and relatively low density, but their brittleness impedes their use as structural materials. Incorporating carbon nanotubes (CNTs) into a brittle ceramic might be expected to provide CNT/ceramic composites with both high toughness and high temperature stability. Until now, however, materials fabrication difficulties have limited research on CNT/ceramic composites. The mechanical failure of CNT/ceramic composites reported previously is primarily attributed to poor CNT-matrix connectivity and severe phase segregation. Here we show that a novel processing approach based on the precursor method can diminish the phase segregation of multi-walled carbon nanotubes (MWCNTs), and render MWCNT/alumina composites highly homogeneous. The MWCNTs used in this study are modified with an acid treatment. Combined with a mechanical interlock induced by the chemically modified MWCNTs, this approach leads to improved mechanical properties. Mechanical measurements reveal that only 0.9 vol% acid-treated MWCNT addition results in 27% and 25% simultaneous increases in bending strength (689.6 ± 29.1 MPa) and fracture toughness (5.90 ± 0.27 MPa m(1/2)), respectively.

No abstract

No abstract

No abstract

No abstract

No abstract

No abstract