The applicability of gallium-based liquid metal alloy has been limited by the oxidation problem. In this paper, we report a simple method to remove the oxide layer on the surface of such alloy to recover its nonwetting characteristics, using hydrochloric acid (HCl) vapor. Through the HCl vapor treatment, we successfully restored the nonwetting characteristics of the alloy and suppressed its viscoelasticity. We analyzed the change of surface chemistry before and after the HCl vapor treatment using X-ray photoelectron spectroscopy (XPS) and low-energy ion-scattering spectroscopy (LEIS). Results showed that the oxidized surface of the commercial gallium-based alloy Galinstan (Ga(2)O(3) and Ga(2)O) was replaced with InCl(3) and GaCl(3) after the treatment. Surface tension and static contact angle on a Teflon-coated glass of the HCl-vapor-treated Galinstan were measured to be 523.8 mN/m and 152.5°. A droplet bouncing test was successfully carried out to demonstrate the nonwetting characteristics of the HCl-vapor-treated Galinstan. Finally, the stability of the transformed surface of the HCl-vapor-treated Galinstan was investigated by measuring the contact angle and LEIS spectra after reoxidation in an ambient environment.

Binary frontal polymerization is a process that involves two different systems polymerizing simultaneously but independently of each other. Various factors including filler choice and initiator concentration can affect front temperature and velocity. Like thermal frontal polymerization systems, binary frontal polymerization of a cyanate ester system and multifunctional acrylate is affected by initiator (amine) concentration and filler choice. Systems with higher viscosities and higher initiator concentrations resulted in higher velocities. Front temperature was rarely affected by filler choice. Aniline concentration and initial monomer ratios had a greater effect on front temperature than filler choice does.

No abstract

Abstract. Composition gradients in miscible liquids can create volume forces resulting in various interfacial phenomena. Experimental observations of these phenomena are related to some difficulties because they are transient, sufficiently weak and can be hidden by gravity driven flows. As a consequence, the question about their existence and about adequate mathematical models is not yet completely elucidated. In this work we present some experimental evidences of interfacial phenomena in miscible liquids and numerical simulations of miscible drops and diffuse interfaces.

The effect of pseudo-gravitational acceleration on the dissolution process of two phase miscible systems has been investigated at high acceleration values using a spinning drop tensiometer with three systems: 1-butanol/water, isobutyric acid/water, and triethylamine/water. We concluded that the dissolution process involves at least three different transport phenomena: diffusion, barodiffusion, and gravitational (buoyancy-driven) convection. The last two phenomena are significantly affected by the centrifugal acceleration acting at the interface between the two fluids, and the coupling with the geometry of the dissolving drop leads to a change of the mass flux during the course of the dissolution process.