The aim of this study is to report on the oral lesions detected in 123 patients diagnosed at the University Hospital of Bari from October 2020 to December 2020, focusing on the correlation of clinical and pathological features in order to purpose a new classification. Methods. General and specialistic anamnesis were achieved and oral examination was performed. The following data were collected: age/gender, general symptoms and form of Covid-19, presence and features of taste disorders, day of appearance of the oral lesions, type and features of oral lesions and day of beginning of therapies. If ulcerative lesions did not heal, biopsy was performed. Results. Many types of oral lesions were found and classified into four groups considering the timing of appearance and the start of the therapies. Early lesions in the initial stages of Covid-19 before the start of therapies was observed in 65.9% of the patients. In the histopathological analysis of four early lesions, thrombosis of small and middle size vessels was always noticed with necrosis of superficial tissues. Conclusion. The presence of oral lesions in early stages of Covid-19 could represent an initial sign of peripheral thrombosis, a warning sign of possible evolution to severe illness. This suggests that anticoagulant therapies should start as soon as possible.

In many viral infections the host cell carries the viral genome without producing viral particles, a phenomenon known as viral latency. The cellular mechanisms by which viral latency is maintained or viral replication is induced are not known. The modulation of intracellular calcium concentrations by calcium ionophores induced Epstein-Barr viral antigens in lymphoblastoid cell lines that carry the virus. When calcium ionophores were used in conjunction with direct activators of protein kinase C (12-O-tetradecanoyl phorbol-13-acetate and a synthetic diacylglycerol), a greater induction of viral antigens was observed than with either agent alone. Activation of protein kinase C may be required for the expression of the viral genome.

The oral microbiota plays a vital role in the human microbiome and oral health. Imbalances between microbes and their hosts can lead to oral and systemic disorders such as diabetes or cardiovascular disease. The purpose of this review is to investigate the literature evidence of oral microbiota dysbiosis on oral health and discuss current knowledge and emerging mechanisms governing oral polymicrobial synergy and dysbiosis; both have enhanced our understanding of pathogenic mechanisms and aided the design of innovative therapeutic approaches as ORALBIOTICA for oral diseases such as demineralization. PubMed, Web of Science, Google Scholar, Scopus, Cochrane Library, EMBEDDED, Dentistry & Oral Sciences Source via EBSCO, APA PsycINFO, APA PsyArticles, and DRUGS@FDA were searched for publications that matched our topic from January 2017 to 22 April 2022, with an English language constraint using the following Boolean keywords: (“microbio*” and “demineralization*”) AND (“oral microbiota” and “demineralization”). Twenty-two studies were included for qualitative analysis. As seen by the studies included in this review, the balance of the microbiota is unstable and influenced by oral hygiene, the presence of orthodontic devices in the oral cavity and poor eating habits that can modify its composition and behavior in both positive and negative ways, increasing the development of demineralization, caries processes, and periodontal disease. Under conditions of dysbiosis, favored by an acidic environment, the reproduction of specific bacterial strains increases, favoring cariogenic ones such as Bifidobacterium dentium, Bifidobacterium longum, and S. mutans, than S. salivarius and A. viscosus, and increasing of Firmicutes strains to the disadvantage of Bacteroidetes. Microbial balance can be restored by using probiotics and prebiotics to manage and treat oral diseases, as evidenced by mouthwashes or dietary modifications that can influence microbiota balance and prevent or slow disease progression.

The aim of the current paper is to review the available literature reporting on comparative studies of heat-cured resins and three-dimensionally printed biomaterials for denture bases in terms of their composition, properties, fabrication techniques and clinical performance. The methodology included applying a search strategy, defining inclusion and exclusion criteria, selecting studies to summarize the results. Searches of PubMed, Scopus, and Embase databases were performed independently by three reviewers to gather literature published between 2018 and 2021. A total of 135 titles were obtained from the electronic databases, and the application of exclusion criteria resulted in the identification of 42 articles pertaining to conventional and 3D printed technology for removable dentures. The main disadvantages of the heat-cured resins for removable dentures are that they require lots of special equipment, skilled personnel and time. Emerging technologies, such as 3D printed dentures, have the potential to alleviate these problems allowing for faster patient rehabilitation. With the development of digital dentistry, it is becoming increasingly necessary to use 3D printed resin materials for the manufacturing of removable dentures. However, further research is required on the existing and developing materials to allow for advancement and increase its application in removable prosthodontics.