The purpose of this study was to compare repetition performance and rating of perceived exertion (RPE) with 1-, 3-, or 5-minute rest intervals between sets of multi and single-joint resistance exercises. Fifteen resistance trained men (23.6 ± 2.64 years, 76.46 ± 7.53 kg, 177 ± 6.98 cm, bench press [BP] relative strength: 1.53 ± 0.25 kg·kg(-1) body mass) completed 12 sessions (4 exercises × 3 rest intervals), with each session involving 5 sets with 10 repetition maximum loads for the free weight BP, machine leg press (LP), machine chest fly (MCF), and machine leg extension (LE) exercises with 1-, 3-, 5-minute rest intervals between sets. The results indicated significantly greater BP repetitions with 3 or 5 minutes vs. 1 minute between sets (p ≤ 0.05); no significant difference was evident between the 3- and 5-minute rest conditions. For the other exercises (i.e., LP, MCF, and LE), significant differences were evident between all rest conditions (1 < 3 < 5; p ≤ 0.05). For all exercises, consistent declines in repetition performance (relative to the first set) were observed for all rest conditions, starting with the second set for the 1-minute condition and the third set for the 3- and 5-minute conditions. Furthermore, significant increases in RPE were evident over successive sets for both the multi and single-joint exercises, with significantly greater values for the 1-minute condition. In conclusion, both multi and single-joint exercises exhibited similar repetition performance patterns and RPE, independent of the rest interval length between sets.

The aim of this paper was to compare the effects of two sequences of resistance exercises (RE), with different intensities but same training volume, on post-exercise blood pressure responses. Sixteen young subjects with previous experience in RE were evaluated during three non-following days in chest press, legpress, pulley pull down, leg curl, shoulder press, and biceps curl. On the first day, the load associated with six maximal repetitions (6RM) were determined for each exercise. On the second day, three sets of 6RM were performed (SEQ6), with a two minute interval between the sets. On the last day, the same procedure was repeated, but using 12 repetitions with 50% of 6RM load (SEQ12). Rest BP was measured before the sequences by auscultatory method. Post-exercise resting BP was measured each 10 minutes by ambulatory BP monitoring during 60 minutes. The magnitude and duration of BP variability were compared by repeated ANOVA measures followed by Tuckey post-hoc test (p < 0.05). A significant reduction in diastolic blood pressure (DBP) was observed in the first 20 minutes after SEQ12, but not after SEQ6. SEQ12 elicited significant decline in systolic blood pressure (SBP), at least during the first 50 minutes after the exercise, while significant reductions were observed in all measures after SEQ6. There were no significant differences between the absolute values of DBP and SBP after both sequences. In conclusion: a) RE had hypotensive effects on blood pressure, mainly SBP; b) the absolute decline of SBP seem not to be influenced by different interactions between workload and number of repetitions; c) higher workloads seem to extend the total time of SBP post-exercise reduction; d) the number of repetitions seems to have more influence on DBP than SBP, but for a short period of time

The aim of this study was to investigate the acute effects of different interset rest intervals on performance of single- and multijoint exercises with near-maximal loads. Fifteen trained men (26.40 ± 4.94 years, 79.00 ± 7.10 kg, 176.6 ± 6.06 cm, 11.80 ± 2.47% body fat, and bench press relative strength: 1.26 ± 0.19 kg·kg of body mass) performed eight sessions (2 exercises × 4 interset rest intervals); each consisting of 5 sets with a 3RM load. The exercises tested were the machine chest fly (MCF) for the single-joint exercise and the barbell bench press (BP) for the multi-joint exercise with 1, 2, 3, and 5 minutes of rest between sets. The results indicated that for the MCF, significantly higher total number of repetitions were completed for the 2- (12.60 ± 2.35 reps; p = 0.027), 3- (13.66 ± 1.84 reps; p = 0.001), and 5-minute (12.93 ± 2.25 reps; p = 0.001) vs. the 1-minute (10.33 ± 2.60 reps) protocol. For the BP, a significantly higher total number of repetitions were completed for 3- (11.66 ± 2.79 reps; p = 0.002) and 5-minute (12.93 ± 2.25 reps; p = 0.001) vs. the 1-minute protocol (7.60 ± 3.52 reps). In addition, subjects completed significantly higher total number of repetitions for the 5-minute (12.93 ± 2.25 reps; p = 0.016) vs. 2-minute (9.53 ± 3.11 reps) protocol. Both exercises presented similar and progressive reductions in repetition performance for all rest protocols along the 5 sets, starting as soon as the second set for the shorter 1-minute rest protocol. In conclusion, to maintain the best consistency in repetition performance, rest intervals of 2 minutes between sets are sufficient for the MCF and 3-5 minutes for the BP. Thus, it appears that longer acute recovery time is needed for a multijoint (core) exercise such as the BP vs. a single-joint (assistance) exercise such as the MCF.

The purpose of this study was to compare different rest intervals between sets on repetition consistency and ratings of perceived exertion (RPE) during consecutive bench press sets with an absolute 3RM (3 repetition maximum) load. Sixteen trained men (23.75 ± 4.21 years; 74.63 ± 5.36 kg; 175 ± 4.64 cm; bench press relative strength: 1.44 ± 0.19 kg/kg of body mass) attended 4 randomly ordered sessions during which 5 consecutive sets of the bench press were performed with an absolute 3RM load and 1, 2, 3, or 5 minutes of rest interval between sets. The results indicated that significantly greater bench press repetitions were completed with 2, 3, and 5 minutes vs. 1-minute rest between sets (p ≤ 0.05); no significant differences were noted between the 2, 3, and 5 minutes rest conditions. For the 1-minute rest condition, performance reductions (relative to the first set) were observed commencing with the second set; whereas for the other conditions (2, 3, and 5 minutes rest), performance reductions were not evident until the third and fourth sets. The RPE values before each of the successive sets were significantly greater, commencing with the second set for the 1-minute vs. the 3 and 5 minutes rest conditions. Significant increases were also evident in RPE immediately after each set between the 1 and 5 minutes rest conditions from the second through fifth sets. These findings indicate that when utilizing an absolute 3RM load for the bench press, practitioners may prescribe a time-efficient minimum of 2 minutes rest between sets without significant impairments in repetition performance. However, lower perceived exertion levels may necessitate prescription of a minimum of 3 minutes rest between sets.