Hard cylinders (4.7 x 10 mm) of two kinds of beta-tricalcium phosphate-monocalcium phosphate monohydrate-calcium sulfate hemihydrate (beta-TCP-MCPM-CSH) cements with and without beta-TCP granules (500-1000 microns) were implanted into holes drilled in rabbit femoral condyles for up to 16 weeks. Empty cavities were used as control. Cement resorption and new bone formation in the cylinders were evaluated with contact microradiography and quantified through an automatic image analysis system. At 4 weeks, both kinds of cement cylinders were surrounded by new bone. At 8 weeks, except for beta-TCP granules, both cement cylinders were almost completely resorbed and replaced by bone tissue. At 16 weeks the bone in the cavities of both cements recovered a trabecular pattern, but only the bone trabeculae in the initial cavity of the cement with beta-TCP granules became thick and mature. However, the cavities of the empty control were still empty and large. These results show that the beta-TCP-MCPM-CSH cements stimulate bone formation and are rapidly replaced by bone tissue. When added with nonresorbable beta-TCP granules, this cement maintains bone formation for a longer time.
Bone union seems to happen more slowly when the defect is filled; however, there are doubts about radiological evaluation of bone union in different published studies. When osteotomy defect was left unfilled in this study, union and filling of 4/5 of the osteotomy site was obtained in 4.2 months for 49 of the 51 cases. Fixation with the locking plate is reliable and provides stable correction and the option for early weight-bearing.
We reviewed radiographs and CT scans of 38 total hip arthroplasties which had dislocated (36 posteriorly; 2 anteriorly) and compared the alignment ofthe prosthetic components with those of 14 uncomplicated arthroplasties. No difference was found between the alignment of the prosthetic components in the two groups. In the seven patients who had reoperations, the cause of dislocation diagnosed by CT was confirmed in only two cases (one retroversion of the cup and one protruding osteophyte). Muscular imbalance rather than malposition of the components was the major factor determining dislocation. CT allows accurate measurement of cup and neck anteversion but contributes little to preoperative planning.
Pre-operative computerised three-dimensional planning was carried out in 223 patients undergoing total hip replacement with a cementless acetabular component and a cementless modular-neck femoral stem. Components were chosen which best restored leg length and femoral offset. The post-operative restoration of the anatomy was assessed by CT and compared with the pre-operative plan. The component implanted was the same as that planned in 86% of the hips for the acetabular implant, 94% for the stem, and 93% for the neck-shaft angle. The rotational centre of the hip was restored with a mean accuracy of 0.73 mm (SD 3.5) craniocaudally and 1.2 mm (SD 2) laterally. Limb length was restored with a mean accuracy of 0.3 mm (SD 3.3) and femoral offset with a mean accuracy of 0.8 mm (SD 3.1). This method appears to offer high accuracy in hip reconstruction as the difficulties likely to be encountered when restoring the anatomy can be anticipated and solved pre-operatively by optimising the selection of implants. Modularity of the femoral neck helped to restore the femoral offset and limb length.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.