No abstract

No abstract

Poly(lactic acid) (PLA) is a relatively brittle polymer, and its low melt strength, ductility, and thermal stability limit its use in various industrial applications. This study aimed to investigate the effect of poly(methyl methacrylate) (PMMA) and PMMA/silica hybrid particles on the mechanical properties, interfacial adhesion, and crystallization behavior of PLA/block acrylic elastomer. PLA/block acrylic elastomer blends exhibit improved flexibility; however, phase separation occurs between PLA and block acrylic elastomer domains. Valid time-temperature superposition (TTS) measurements of viscoelastic behavior were obtained and exhibited interfacial adhesion with the addition of PMMA or PMMA/silica in PLA/block acrylic elastomer blends. In particular, the phase separation temperature was increased by the incorporation of PMMA/silica hybrid particles, which suggests a potential role for these particles in improving the phase stability. In addition, PMMA inhibits crystallization, while PMMA/silica acts as a nucleating agent, thus increasing the crystallization rate and crystallinity degree.

Cellulose nanofibrils (CNFs) have attracted much attention because of their renewability and potential biocompatibility. However, CNFs are extremely hydrophilic due to the presence of a large number of hydroxyl groups, limiting their use as a water-resistant material. In this work, we controlled the adsorption behavior of silica nanoparticles on the surface of CNFs by adjusting the synthesis conditions. The silica nanoparticle size and packing efficiency on the CNF surface could be controlled by varying the ammonium hydroxide and water concentrations. In addition, hexadecyltrimethoxysilane (HDTMS) was successfully grafted onto CNF or CNF/silica nanocomposite surfaces, and the quantitative content of organic/inorganic substances in HDTMS was analyzed through XPS and TGA. The HDTMS-modified CNF/silica nanocomposites were more advantageous in terms of hydrophobicity than the HDTMS-modified CNF composites. This is because the silica nanoparticles were adsorbed on the surface of the CNFs, increasing the surface roughness and simultaneously increasing the amount of HDTMS. As a result, the HDTMS-modified CNFs showed a water contact angle (WCA) of ~80°, whereas HDTMS-modified CNF/silica nanocomposites obtained superhydrophobicity, with a WCA of up to ~159°. This study can provide a reference for the expansion of recyclable eco-friendly coating materials via the adsorption of silica nanoparticles and hydrophobic modification of CNF materials.

This study aimed to investigate synthesis and adsorption behavior of silica nanoparticles onto polyvinylpyrrolidone (PVP)‐functionalized poly(methyl methacrylate) under various conditions such as methanol/water ratio, ammonium hydroxide concentration, polymer contents, tetraethylorthosilicate contents, and total volume of solvent via sol–gel method. First, the copolymerization of methyl acrylate as a comonomer and 1‐dodecanethiol as a chain transfer agent increased the thermal stability of the product; however, the uniformity of the PMMA particles decreased because of the chain transfer reaction. Second, the adsorption behavior and size of silica nanoparticles could be controlled by adjusting the silica synthesis conditions. The adsorbed silica particle size was greatly influenced by the ammonium hydroxide concentration and the addition of water further enhanced the size increase. However, increasing the water content reduced the packing efficiency of the adsorbed silica particles. Increasing the PVP‐functionalized PMMA content at a fixed TEOS content linearly decreased the silica particle size. But TEOS concentration did not significantly affect the silica particle size. © 2020 Wiley Periodicals, Inc. J. Polym. Sci. 2020, 58, 662–672