The tensile properties of the supraspinatus tendon were investigated in 11 shoulders from fresh cadavers. The tendon was divided into three longitudinal strips: anterior, middle, and posterior. Each specimen was mounted on a materials testing machine, with four fluorescent markers placed on both surfaces of the tendon strip. The positions of these markers were recorded during the test by two synchronized video cameras. Load-deformation and strain curves were determined, and the stress-strain curve, strength, and modulus of elasticity were calculated. The posterior strip was thinner in cross section than the others (p = 0.0355). The ultimate load and ultimate stress were significantly greater in the anterior strip (16.5 +/- 7.1 MPa) than in the middle (6.0 +/- 2.6 MPa) and posterior (4.1 +/- 1.3 MPa) strips (p < 0.0001). The modulus of elasticity also was significantly greater in the anterior strip (p < 0.0001), but there was no significant difference between the superficial and deep surfaces. It is concluded that the anterior portion of the supraspinatus tendon is mechanically stronger than the other portions, and it seems to perform the main functional role of the tendon.

No abstract

Cartilage repair by autologous periosteal arthroplasty is enhanced by continuous passive motion (CPM) of the joint after transplantation of the periosteal graft. However, the mechanisms by which CPM stimulate chondrogenesis are unknown. Based on the observation that an oscillating intra-synovial pressure fluctuation has been reported to occur during CPM (0.&10 kPa), it was hypothesized that the oscillating pressure experienced by the periosteal graft as a result of CPM has a beneficial effect on the chondrogenic response of the graft. We have developed an in vitro model with which dynamic fluid pressures (DFP) that mimic those during CPM can be applied to periosteal explants while they are cultured in agarose gel suspension. In this study periosteal explants were treated with or without DFP during suspension culture in agarose, which is conducive to chondrogenesis. Different DFP application times (30 min, 4 h, 24 Wday) and pressure magnitudes (13, 103 kPa or stepwise 13 to 54 to 103 kPa) were compared for their effects on periosteal chondrogenesis. Low levels of DFP (13 kPa at 0.3 Hz) significantly enhanced chondrogenesis over controls (34 f 7% vs 14 f 5%; P < 0.05), while higher pressures (103 kPa at 0.3 Hz) completely inhibited chondrogenesis, as determined from the percentage of tissue that was determined to be cartilage by histomorphometry. Application of low levels of DFP to periosteal explants also resulted in significantly increased concentrations of Collagen Type I1 protein (43 f 8% vs 10 f 5%; P < 0.05). New proteoglycan synthesis, as measured by 35S-sulphate uptake was increased by 30% in periosteal explants stimulated with DFP (350 f 50 DPM vs 250 f 75 DPM of 35S-sulphate uptakdpg total protein), when compared to controls though this difference was not statistically significant. The DFP effect at low levels was dose-dependant for time of application as well, with 4 hlday stimulation causing significantly higher chondrogenesis than just 30 midday (34 f 7 vs 12 f 4% cartilage; P < 0.05) and not significantly less than that obtained with 24 hlday of DFP (48 f 9% cartilage, P > 0.05). These observations may partially explain the beneficial effect on cartilage repair by CPM. They also validate an in vitro model permitting studies aimed at elucidating the mechanisms of action of mechanical factors regulating chondrogenesis. The fact that these tissues were successfully cultured in a mechanical environment for six weeks makes it possible to study the actions of mechanical factors on the entire chondrogenic pathway, from induction to maturation. Finally, these data support the theoretical predictions regarding the role of hydrostatic compression in fracture healing.

To develop a method of tendon attachment to a metallic endoprosthesis, we evaluated fixation strength, clinical function of the tendon, and morphological changes in an experimental model. The canine supraspinatus tendon was removed from the greater tubercle of the humerus and attached to a titanium prosthesis. In 12 animals, the bone block underlying the tendon insertion was preserved and attached in one limb; the soft part of the tendon was attached directly to the prosthesis in the contralateral limb. Fixation strength was evaluated after 16 weeks of in vivo implantation (12 specimens) and compared with the in vitro fixation strength (12 specimens) and with intact normal controls (six specimens from cadavera). Function of the tendon in vivo was evaluated by force-plate analysis (at 3-week intervals). All specimens were evaluated histologically. Sixteen weeks after surgery, the tendon-bone block attachment was significantly stronger (mean, 16%) than the direct tendon attachment and not significantly different from the normal control, and the direct tendon attachment was significantly weaker (mean, 68%) than the normal control. There was significantly more weight-bearing on the limbs with a tendon-bone block attachment than on the limbs with a direct tendon attachment at both 3 and 6 weeks postoperatively. Both front legs showed increased weight-bearing with time, but the differences were not statistically significant. Anchorage by tissue ingrowth to the titanium prosthesis was found consistently--there was bone ingrowth in the tendon-bone block attachments and fibrous tissue ingrowth in the direct tendon attachments. When a bone block was preserved, the strength and stiffness were comparable with those of a normal tendon insertion.(ABSTRACT TRUNCATED AT 250 WORDS)

In biomedical research, agarose gel is widely used in tissue culture systems because it permits growing cells and tissues in a three-dimensional suspension. This is especially important in the application of tissue engineering concepts to cartilage repair because it supports the cartilage phenotype. Mechanical loading, especially compression, plays a fundamental role in the development and repair of cartilage. It would be advantageous to develop a system where cells and tissues could be subjected to compression so that their responses can be studied. There is currently no information on the pressure response of agarose gel when pressure is applied to the gas phase of a culture system. To understand the transmission of pressure through the gel, we set up an apparatus that would mimic an agarose suspension tissue culture system. This consisted of a sealed metal cylinder containing air as well as a layer of agarose submerged in culture medium. Pressure responses were recorded in the air, fluid, gel center, and gel periphery using various frequencies, pressures, gel volumes, and viscosities. Regression analyses show an almost perfect linear relation between gas and gel pressures (r(2) = 0.99987, p < 0.0001, f(x) = 0.9982 x - 0.0286). The pressure transmission was complete and immediate, throughout the range of the applied pressures, frequencies, volumes, and viscosities tested. Applying dynamic pressure to the gas phase results in reproducible pressure in the agarose and, therefore, validates the use of agarose tissue culture systems in studies employing dynamic pressurization in cartilage tissue engineering.