This study presents in situ monitoring data of three different glazing systems over a period of one year. An insulated glass unit (IGU), a Vacuum Insulated Glass hybrid unit (VIG-hybrid) and an opaque architectural insulation module (AIM) were monitored under the equivalent environmental condition in this study. Different issues were observed and analyzed. It was found that the Ug-value cited by the manufacturers agrees with the Ug-values derived from the measured data, to within less than 5 % for the IGU and the VIG-hybrid. The consistency of the Ug-value of each glazing types one year after the start of monitoring was validated for similar environmental conditions. Depending on the magnitude of the resistance to heat flow, an increasing Ug-value was observed for a higher temperature difference between the inside and outside environments. The effect is much more significant for the glazing type with the largest Ug-value (IGU) and less significant for the glazing types with a high thermal resistance (VIG-hybrid, AIM).
In the structural design of facade glazing, various types of loads such as dead weight, wind and climatic loads (pressure differences) must be taken into account. In practice, however, there are many cases of damage that can be attributed to direct solar radiation. In these cases, a so-called thermally induced fracture takes place, which can occur as a result of large in-plane temperature differences within the glass. Due to the increasing complexity of glazing constructions, this load type should be taken into account in future glass design. For this reason, thermal-mechanical investigations, were conducted. Commercially used double and triple insulating glass units were considered as vertical glazing and the solar direct absorptance per glass pane was varied. For numerical calculations, measured temperature data from the German Weather Service and free available Clear Sky model data were used as meteorological input. The results show that solar irradiance, along with temperature, is the driving influence on the thermally induced stress in insulating glass units. The investigations indicate that the inner pane becomes relevant on colder days and the outer pane on warmer days. Results also show, that the level of the outside temperature plays a negligible role for the thermally induced stresses of the middle pane.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.