No abstract

Cefepime is an antibiotic with a broad spectrum of antimicrobial activity. However, this antibiotic has several side effects and a high degradation rate. For this reason, the preparation and characterization of new liposomes that are able to encapsulate this antibiotic seem to be an important research line in the pharmaceutical industry. Anionic and cationic liposomes were prepared and characterized. All cationic structures contained the same cationic surfactant, N,N,N-triethyl-N-(12-naphthoxydodecyl)ammonium. Results showed a better encapsulation-efficiency percentage (EE%) of cefepime in liposomes with phosphatidylcholine and cholesterol than with 1,2-dioleoyl-sn-glycero-3-phosphoethanolamine (DOPE). The presence of cholesterol and the quantity of egg-yolk phospholipid in the liposome increased the encapsulation percentage. The bactericidal activity against Escherichia coli of cefepime loaded into liposomes with phosphatidylcholine was measured. The inhibitory zone in an agar plate for free cefepime was similar to that obtained for loaded cefepime. The growth-rate constant of E. coli culture was also measured in working conditions. The liposome without any antibiotic exerted no influence in such a rate constant. All obtained results suggest that PC:CH:12NBr liposomes are biocompatible nanocarriers of cefepime that can be used in bacterial infections against Escherichia coli with high inhibitory activity.

Given the high toxicity of the anthracycline antibiotic doxorubicin (DOX), it is relevant to search for nanocarriers that decrease the side effects of the drug and are able to transport it towards a therapeutic target Here, the encapsulation of DOX by p-sulfocalix[6]arene (calix) has been studied. The interaction of DOX with the macrocycle, as well as with DNA, has been investigated and the equilibrium constant for each binding process estimated. The results showed that the binding constant of DOX to DNA, K , is three orders of magnitude higher than that to calix, K . The ability of calixarenes to encapsulate DOX molecules, as well as the capability of the DOX molecules included into the inner cavity of the macrocycle to bind with DNA have been examined. Cytotoxicity measurements were done in different cancer and normal cell lines to probe the decrease in the toxicity of the encapsulated DOX. The low toxicity of calixarenes has also been demonstrated for different cell lines.

The formation of calixarene-based liposomes was investigated, and the characterization of these nanostructures was carried out using several techniques. Four amphiphilic calixarenes were used. The length of the hydrophobic chains attached to the lower rim as well as the nature of the polar group present in the upper rim of the calixarenes were varied. The lipid bilayer was formed with one calixarene and with the phospholipid 1,2-dioleoyl-sn-glycero-3-phosphoethanolamine, DOPE. The cytotoxicity of the liposomes for various cell lines was also studied. From the results obtained, the liposomes formed with the least cytotoxic calixarene, (TEAC12)4, were used as nanocarriers of both nucleic acids and the antineoplastic drug doxorubicin, DOX. Results showed that (TEAC12)4/DOPE/p-EGFP-C1 lipoplexes, of a given composition, can transfect the genetic material, although the transfection efficiency substantially increases in the presence of an additional amount of DOPE as coadjuvant. On the other hand, the (TEAC12)4/DOPE liposomes present a high doxorubicin encapsulation efficiency, and a slow controlled release, which could diminish the side effects of the drug.

No abstract

The use of collagen and gelatin in the field of regenerative medicine is widely extended. However, most of the studies in this topic are focused on the scaffolds’ properties, but only a few are related to the properties of the raw material used. The raw material analysis not only consists of a study of the composition, but also of the denaturation degree that can influence the processing and properties of the structure of the scaffold. Thus, the denaturation degree analysis of different collagen proteins was performed and assessed by the comparison of four different methods: differential scanning calorimetry (DSC), Fourier transform Infrared Spectroscopy (FTIR) and circular dichroism (CD) spectra and sulfhydryls content analysis. DSC measurements put forward a glass transition between 88°C and 95°C as well as from the FTIR measurements; the characteristic peaks for proteins are evidenced. However, from the sulfur content, only a small proportion of free sulfhydryls are present with respect to their total amount. In addition, CD spectra allow to estimate the secondary structure of the protein by the analysis of the α-helix and β-strand and also quantify the denaturation degree with the ‘positive/negative ratio’ (RPN) from the CD profiles, obtaining values in the range between 25% and 100%.

A study of a dinitro-diester calix[4]arene (5,17-(3-nitrobenzylideneamino)-11,23-di-tert-butyl-25,27-diethoxycarbonyl methyleneoxy-26,28-dihydroxycalix[4]arene) interaction with calf-thymus DNA was carried out using several techniques. The measurements were done at various molar ratios X=[calixarene]/[DNA]. Results show diverse changes in the DNA conformation depending on the X value. Thus, at low macrocycle concentrations, the calixarene binds to the polynucleotide. This interaction, mainly in groove mode, weakens the hydrogen bonds between base pairs of the helix inducing denaturation of the double strands, as well as condensation of the macromolecule, from an extended coil state to a globular state. An opposite effect is observed at X molar ratios higher than 0.07. The de-condensation of DNA happens, that is, the transition from a compact state to a more extended conformation, probably due to the stacking of calixarene molecules in the solution. Results also show the importance of making a proper choice of the system under consideration.

In this study, we report on the use of poly(cyclohexylmethacrylate) (PCHMA) as an alternative to the commonly used poly(methylmethacrylate) (PMMA) for the design of efficient luminescent solar concentrators (LSCs). PCHMA was selected due to its less polar nature with respect to PMMA, a characteristic that was reported to be beneficial in promoting the fluorophore dispersibility in the matrix, thus maximizing the efficiency of LSCs also at high doping. In this sense, LSC thin films based on PCHMA and containing different contents of Lumogen F Red 305 (LR, 0.2–1.8 wt%) demonstrated optical efficiencies (ηopt) comprising between 9.5% and 10.0%, i.e., about 0.5–1% higher than those collected from the LR/PMMA systems. The higher LR/polymer interactions occurred using the PCHMA matrix maximized the solar harvesting characteristics of the fluorophore and limited the influence of the adverse dissipative phenomena on the fluorophore quantum efficiency. These effects were also reflected by varying the LSC film thickness and reaching maximum ηopt of about 11.5% in the case of PCHMA films of about 30 µm.