Scanning laser projection using resonant actuated MEMS scanning mirrors is expected to overcome the current limitation of small display size of mobile devices like cell phones, digital cameras and PDAs. Recent progress in the development of compact modulated RGB laser sources enables to set up very small laser projection systems that become attractive not only for consumer products but also for automotive applications like head-up and dash-board displays. Within the last years continuous progress was made in increasing MEMS scanner performance. However, only little is reported on how mass-produceability of these devices and stable functionality even under harsh environmental conditions can be guaranteed. Automotive application requires stable MEMS scanner operation over a wide temperature range from -40° to +85°Celsius. Therefore, hermetic packaging of electrostatically actuated MEMS scanning mirrors becomes essential to protect the sensitive device against particle contamination and condensing moisture. This paper reports on design, fabrication and test of a resonant actuated two-dimensional micro scanning mirror that is hermetically sealed on wafer level. With resonant frequencies of 30kHz and 1kHz, an achievable Theta-D-product of 13mm.deg and low dynamic deformation <20nm RMS it targets Lissajous projection with SVGA-resolution. Inevitable reflexes at the vacuum package surface can be seperated from the projection field by permanent inclination of the micromirror

The paper presents the design and characterization of a smart IC driver for MEMS scanning micromirrors. The driver integrates in 0.18 μm BCD technology the cascade of the following circuits: resistor-string DAC circuitry for direct interface to a host digital processing unit, a voltage buffer between the DAC and the High-Voltage (HV) stage, and a fully-differential HV amplifier with programmable output common mode. A couple of the designed DACs permits to generate, starting from digital samples, low-voltage analog stimuli. This signal amplified up to 25 V by the HV stage provides the electrostatical actuation of the micromirror. When compared to state-of-the-art the driver offers an integrated solution with good dynamic performances.

No abstract

The design of a high voltage fully differential driver in a 0.18 μm Bipolar-CMOS-DMOS (BCD) technology for the actuation of a double axis scanning micromirror is presented. The proposed circuit has a driving voltage capability up to 25 V and a low Total Harmonic Distortion in order to prevent the excitation of unwanted micromirror's higher resonating modes. This design features a low voltage input stage and a programmable output common mode voltage. After a description of the circuit, results of simulations performed with an equivalent electrical model of the micromirror are presented

No abstract