An acidic diet has been associated with erosive tooth wear. However, some people who consume dietary acids develop erosive tooth wear and some do not. This review paper provides an overview of the risk factors of dietary acid consumption which increase the likelihood of developing severe erosive tooth wear. Increased frequency of dietary acid consumption, particularly between meals appears to be the predominant risk factor. However, habitually drinking acidic drinks by sipping them slowly or swishing, rinsing or holding acidic drinks in the mouth before swallowing will also increase risk of progression. Consuming fruit over long time periods at a single sitting and dietary acids being served at increased temperatures have also been implicated. Additions of fruit or fruit flavourings to drinks and regular consumption of vinegars, pickles, acidic medications or acidic sugar-free sweets are potential hidden risk factors that should be discussed with patients at risk of erosive tooth wear progression. Behaviour change is difficult to achieve but specific, targeted behavioural interventions and offering alternatives may increase success.

A NovaMin desensitising dentifrice resulted in tubule occlusion even at high brushing forces. There was minimal increase in surface roughness at the lower (100g) brushing force.

ObjectivesTo determine if Sa roughness data from measuring one central location of unpolished and polished enamel were representative of the overall surfaces before and after erosion.MethodsTwenty human enamel sections (4x4 mm) were embedded in bis-acryl composite and randomised to either a native or polishing enamel preparation protocol. Enamel samples were subjected to an acid challenge (15 minutes 100 mL orange juice, pH 3.2, titratable acidity 41.3mmol OH/L, 62.5 rpm agitation, repeated for three cycles). Median (IQR) surface roughness [Sa] was measured at baseline and after erosion from both a centralised cluster and four peripheral clusters. Within each cluster, five smaller areas (0.04 mm2) provided the Sa roughness data.ResultsFor both unpolished and polished enamel samples there were no significant differences between measuring one central cluster or four peripheral clusters, before and after erosion. For unpolished enamel the single central cluster had a median (IQR) Sa roughness of 1.45 (2.58) μm and the four peripheral clusters had a median (IQR) of 1.32 (4.86) μm before erosion; after erosion there were statistically significant reductions to 0.38 (0.35) μm and 0.34 (0.49) μm respectively (p<0.0001). Polished enamel had a median (IQR) Sa roughness 0.04 (0.17) μm for the single central cluster and 0.05 (0.15) μm for the four peripheral clusters which statistically significantly increased after erosion to 0.27 (0.08) μm for both (p<0.0001).ConclusionMeasuring one central cluster of unpolished and polished enamel was representative of the overall enamel surface roughness, before and after erosion.

This study demonstrates that outer enamel is innately more resistant to erosion which is clinically relevant as once there has been structural breakdown at this level the effects of erosive wear will be accelerated.

If citing, it is advised that you check and use the publisher's definitive version for pagination, volume/issue, and date of publication details. And where the final published version is provided on the Research Portal, if citing you are again advised to check the publisher's website for any subsequent corrections.

This study demonstrates a method for precise surface texture measurement of natural human enamel. Measurement precision was superior for polished flat enamel in contrast to natural enamel however, natural enamel responds very differently to polished enamel when exposed to erosion challenges. Therefore, thus future studies characterising enamel surface changes following erosion on natural enamel may provide more clinically relevant responses in comparison to polished enamel.

No abstract

To evaluate pharmacy, dental and dental therapy undergraduate students' perceived competence of interprofessional working before and after attending an interprofessional education (IPE) Gerodontology workshop.Background: Whilst there is international recognition of the importance of collaboration between the dental profession and systemic healthcare providers to enhance patient care, there remains a paucity of research into IPE in Gerodontology. Materials and Methods: Pharmacy, dental and dental therapy undergraduate students attended a 2-hour Gerodontology case-based workshop. Students completed anonymised Interprofessional Collaborative Competencies Attainment Surveys (ICCAS) before and after attendance.Results: 108 questionnaires were received, 7 were withdrawn (1 incomplete with only pre-workshop side completed, 6 did not identify degree programme). From 101 included questionnaires, 37 were from pharmacy, 56 dental and 8 dental therapy students resulting in response rates of 84%, 82% and 67%, respectively. Each student group recorded an increase in positive reflective competence median (IQR) after taking part in the workshop. Overall median (IQR) reflective competence before the workshop was 6 (1), 5 (2) and 6 (2) for pharmacy, dental and dental therapy students, respectively, which increased to 7 (1) for all groups. There was variability in reflective competence before attending the workshop between dental and pharmacy students for two questions, and dental and dental therapy students for two different questions. Conclusion:All students reported increased reflective competence of interprofessional working following the workshop. These findings suggest that introduction of IPE events into Gerodontology curricula may improve student understanding and appreciation of interprofessional working when providing care for older people.