The Minicare cTnI assay is a sensitive and precise, clinical usable test for determination of cTnI concentration that can be used in a near-patient setting as an aid in the diagnosis of acute myocardial infarction.

Point-of-care B-type natriuretic peptide (BNP) testing with adequate analytical performance has the potential to improve patient flow and provide primary care givers with easy-to-use advanced diagnostic tools in the management of heart failure. We present the analytical evaluation of the Minicare BNP immunoassay under development on the Minicare I-20 platform for point-of-care testing. Analytical performance was evaluated using EDTA venous whole blood, EDTA plasma and capillary whole blood. Method comparison with a lab-testing system was performed using samples from 187 patients. Normal values were determined based on 160 healthy adults, aging from 19 to 70 years. Limit of blank (LoB), limit of detection (LoD) were determined to be 3.3 ng/L, 5.8 ng/L. Limit of quantitation (LoQ) in whole blood at 20% and 10% coefficient of variation (CV) was found < 9 ng/L and <30 ng/L respectively without significant differences between EDTA whole blood and EDTA plasma. Total CV was found to be from 6.7% to 9.7% for BNP concentrations between 92.6 and 3984 ng/L. The sample type comparison study demonstrated correlation coefficients between 0.97 and 0.99 with slopes between 1.03 and 1.09 between the different samples. Method comparison between Minicare BNP and Siemens ADVIA Centaur BNP demonstrated a correlation coefficient of 0.92 with a slope of 1.06. The 97.5% URL of a healthy population was calculated to be 72.6 ng/L. The Minicare BNP assay is a robust, easy-to-use and sensitive test for rapid determination of BNP concentrations that can be used in a near-patient setting.

We experimentally demonstrate the sensitivity of an integrated detection scheme for small superparamagnetic beads, intended for medical diagnostic applications. Detection is based on the giant magnetoresistance effect of a 100×3μm2 magnetic multilayer strip. A conductive wire to magnetize the superparamagnetic beads is integrated on the same substrate. By scanning a single bead over the wires and sensor strip using an atomic force microscope, we simultaneously measure topography and sensor resistivity in a three-dimensional volume above the sensor. The observations can be explained well by means of the macroscopically measured sensor resistivity curve and the magnetization of the beads, combined with the Biot-Savart law for the magnetic field of the wire. From these encouraging results, we project that it is possible to detect even a single 300nm superparamagnetic bead on our sensor.