As wind penetration increases in power systems around the world, new challenges to the controllability and operation of a power system are encountered. In particular, frequency response is impacted when a considerable amount of power-electronics interfaced generation, such as wind, is connected to the system. This paper uses small-signal analysis and dynamic simulation to study frequency response in power systems and investigate how Type-3 DFAG wind turbines can impact this response on a test power system, whose frequency response is determined mainly by a frequency-regulation mode. By operating the wind turbines in a deloaded mode, a proposed pitch-angle controller is designed using a root-locus analysis. Time simulations are used to demonstrate the transient and steady-state performance of the proposed controller in the test system with 25% and 50% wind penetration.Index Terms-DFAG wind turbine, frequency response, linear analysis, pitch angle control, root-locus analysis, wind generation.

This paper describes the design and implementation of a proof-of-concept Pacific dc Intertie (PDCI) wide area damping controller and includes system test results on the North American Western Interconnection (WI). To damp inter-area oscillations, the controller modulates the power transfer of the PDCI, a ±500 kV dc transmission line in the WI. The control system utilizes real-time phasor measurement unit (PMU) feedback to construct a commanded power signal which is added to the scheduled power flow for the PDCI. After years of design, simulations, and development, this controller has been implemented in hardware and successfully tested in both open and closed-loop operation. The most important design specifications were safe, reliable performance, no degradation of any system modes in any circumstances, and improve damping to the controllable modes in the WI. The main finding is that the controller adds significant damping to the modes of the WI and does not adversely affect the system response in any of the test cases. The primary contribution of this paper, to the state of the art research, is the design methods and test results of the first North American real-time control system that uses wide area PMU feedback.

No abstract

No abstract

As a result of the increase in penetration of inverter-based generation such as wind and solar, the dynamics of the grid are being modified. These modifications may threaten the stability of the power system since the dynamics of these devices are completely different from those of rotating generators. Protection schemes need to evolve with the changes in the grid to successfully deliver their objectives of maintaining safe and reliable grid operations. This paper explores the theory of traveling waves and how they can be used to enable fast protection mechanisms. It surveys a list of signal processing methods to extract information on power system signals following a disturbance. The paper also presents a literature review of traveling wave-based protection methods at the transmission and distribution levels of the grid and for AC and DC configurations. The paper then discusses simulations tools to help design and implement protection schemes. A discussion of the anticipated evolution of protection mechanisms with the challenges facing the grid is also presented.

As power systems become more and more interconnected, the inter-area oscillations has become a serious factor limiting large power transfer among different areas. Underdamped (Undamped) inter-area oscillations may cause system breakup and even lead to large-scale blackout. Traditional damping controllers include Power System Stabilizer (PSS) and Flexible AC Transmission System (FACTS) controller, which adds additional damping to the inter-area oscillation modes by affecting the real power in an indirect manner. However, the effectiveness of these controllers is restricted to the neighborhood of a prescribed set of operating conditions. In this paper, decentralized robust controllers are developed to improve the damping ratios of the inter-area oscillation modes by directly affecting the real power through the turbine governing system. The proposed control strategy requires only local signals and is robust to the variations in operation condition and system topology. The effectiveness of the proposed robust controllers is illustrated by detailed case studies on two different test systems.

No abstract

Low frequency electromechanical oscillations can pose a threat to the stability of power systems if not properly addressed. This paper proposes a novel methodology to damp these inter-area oscillations using loads, the demand side of the system. In the proposed methodology, loads are assigned to an aggregated cluster whose demand is modulated for oscillation damping. The load cluster control action is obtained from an optimal output feedback control (OOFC) strategy. The paper presents an extension to the regular OOFC formulation by imposing a constraint on the sum of the rows in the optimal gain matrix. This constraint is useful when the feedback signals are generator speeds. In this case, the sum of the rows of the optimal gain matrix is the droop gain of each load actuator. Time-domain simulations of a largescale power system are used to demonstrate the efficacy of the proposed control algorithm. Two different cases are considered: a power imbalance and a line fault. The simulation results show that the proposed controllers successfully damp inter-area oscillations under different operating conditions and with different clustering for the events considered. In addition, the simulations illustrate the benefit of the proposed extension to the OOFC that enable load to provide a combination of droop control and small signal stability augmentation.