No abstract

No abstract

Based on the great advantages of an inner hollow structure and excellent solid counterpart capacity, complex hierarchical structures have been widely used as electrodes for lithium‐ion batteries. Herein, hierarchical yolk–shell Cu2O@CuO‐decorated RGO (YSRs) was designed and synthesized via a multi‐step approach. Octahedron‐like Cu2O‐decorated RGO was firstly produced, in which GO was reduced slightly while cuprous oxide was synthesized. Subsequently, the controlled oxidation of Cu2O@RGO led to the synthesis of special YSRs, which were composed of a solid Cu2O core, spur‐CuO, CuO shell, and RGO covered. As anode materials, YSRs could provide considerable capacity density. Meanwhile, the void existed between shells and solid active materials retaining the advantages of inner hollow structure. As a result, the unique architecture of the materials renders the composites with enhanced electronic and ionic diffusion kinetics, high specific capacity (~894 mAh g‐1, 0.1C), and an excellent rate capability.

A stable and highly sensitive graphene/hydrogel strain sensor is designed by introducing glycerol as a co-solvent in the formation of a hydrogel substrate and then casting a graphene solution onto the hydrogel in a simple, two-step method. This hydrogel-based strain sensor can effectively retain water in the polymer network due to the formation of strong hydrogen bonding between glycerol and water. The addition of glycerol not only enhances the stability of the hydrogel over a wider temperature range, but also increases the stretchability of the hydrogel from 800% to 2000%. The enhanced sensitivity can be attributed to the graphene film, whereby the graphene flakes redistribute to optimize the contact area under different strains. The careful design enables this sensor to be used in both stretching and bending modes. As a demonstration, the as-prepared strain sensor was applied to sense the movement of finger knuckles. Given the outstanding performance of this wearable sensor, together with the proposed scalable fabrication method, this stable and sensitive hydrogel strain sensor is considered to have great potential in the field of wearable sensors.

No abstract

For the first time, we are reporting the synthesis of Au100-xPtx nanoporous materials in the size range of 7-10 nm through the galvanic replacement of Ag by Pt from Au100-xAg2x spherical nano-alloys (x = 20, 15, 10 and 5) in an aqueous medium. The galvanic replacement reaction follows the 'Volmer-Weber' growth mode, resulting in the formation of surface bound platinum islands on a nanoporous gold surface. The high angle annular dark field image and low angle X-ray diffraction studies confirm the presence of nanoporous Au100-xPtx NPs. The electrochemical studies using the Au85Pt15/C catalyst show excellent methanol tolerance behaviour and better performance towards oxygen reduction reaction (ORR) in terms of high mass activity, mass-specific activity and figure of merit (FOM) when compared to HiSPEC Pt/C commercial catalyst. Preliminary studies on a full cell using nanoporous Au85Pt15/C (loading 1.0 mg cm(-2)) as the cathode material and Pt-Ru/C (loading: 0.5 mg cm(-2)) as the anode material performed better (38 mW cm(-2)) than the HiSPEC Pt/C cathode material (16 mW cm(-2)).

No abstract

No abstract