With the influence of intense solar radiation heat and the greater temperature difference between day and night, surface concrete with a drastic temperature change can easily experience a great nonlinear temperature difference, which increases the risk of early-age concrete cracking. In this study, a distributed optical fiber temperature sensing (DTS) system is used to monitor the surface temperature gradient of concrete in real time, and a solar radiation heat monitoring test is also carried out based on the Baihetan project. Based on this, a solar radiation loading model and a finite element model of a typical pouring block considering solar radiation are established. Combined with the measured temperature data and different calculation conditions, the surface temperature changes of medium-heat and low-heat concrete experiencing solar radiation are analyzed, and the temperature control effect of surface concrete with different surface insulation measures is further analyzed. The results show that the temperature variation of medium-heat concrete at the same depth is more obvious than that of low-heat concrete. Additionally, the temperature variation of low-heat concrete is noticeable within 20 cm of the top surface. In addition, in an intense solar radiation environment, covering the concrete with a 4- or 5-centimeter-thick polyethylene coil can effectively control the surface temperature gradient and maximum daily amplitude of low-heat concrete, and surface concrete cured by running water has a significant temperature control effect. Therefore, it is suggested that 22–24 °C water temperatures be used for water curing during periods of intense solar radiation during the day and a 4-centimeter-thick polyethylene coil be used for coverage at night. These study results have been employed in the Baihetan project to optimize the temperature control scheme of the pouring blocks.
Concrete thermal parameters in a natural pouring environment are essential inputs for simulating the temperature field of a concrete dam. This paper proposes a two-stage thermal parameters inversion method for a concrete dam based on optimal temperature measuring point selection to improve the accuracy of parameters. Firstly, a selection method of optimal measuring point for thermal parameters inversion is presented and the temperature response sensitivity of measuring points when the parameters disturb is taken as the critical evaluation index. And then, an inversion model is established based on support vector regression (SVR) and particle swarm optimization (PSO). Finally, the proposed method is applied to the thermal parameter inversion of a concrete dam. The results show that the proposed method is effective for improving the inversion accuracy and obtaining accurate parameters. The average error of the inversion results based on the SVR-PSO model is 28.54% lower than that of the genetic algorithm optimization using a back propagation neural network (BPNN-GA). Besides that, the average error of the inversion results based on the optimal measurement points is 35.57% lower than that of the nonoptimized ones.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.