To improve the energy harvesting efficiency of the piezoelectric device, a stack units-based structure was developed and verified. Factors such as stress distribution, load resistance, loads, and loading times influencing the piezoelectric properties were investigated using theoretical analysis and experimental tests. The results show that the unit number has a negative relationship with the generated energy and the stress distribution has no influence on the power generation of the piezoelectric unit array. However, with a small stress difference, units in a parallel connection can obtain high energy conversion efficiency. Additionally, loaded with the matched impedance of 275.0 kΩ at 10.0 kN and 10.0 Hz, the proposed device reached a maximum output power of 84.3 mW, which is enough to supply the low-power sensors. Moreover, the indoor load test illustrates that the electrical performance of the piezoelectric device was positively correlated with the simulated loads when loaded with matched resistance. Furthermore, the electrical property remained stable after the fatigue test of 100,000 cyclic loads. Subsequently, the field study confirmed that the developed piezoelectric device had novel piezoelectric properties with an open-circuit voltage of 190 V under an actual tire load, and the traffic parameters can be extracted from the voltage waveform.
Micro-hotplate gas sensors are widely used in air quality monitoring, identification of hazardous chemicals, human health monitoring, and other fields due to their advantages of small size, low power consumption, excellent consistency, and fast response speed. The micro-hotplate gas sensor comprises a micro-hotplate and a gas-sensitive material layer. The micro-hotplate is responsible for providing temperature conditions for the sensor to work. The gas-sensitive material layer is responsible for the redox reaction with the gas molecules to be measured, causing the resistance value to change. The gas-sensitive material film with high stability, fantastic adhesion, and amazing uniformity is prepared on the surface of the micro-hotplate to realize the reliable assembly of the gas-sensitive material and the micro-hotplate, which can improve the response speed, response value, and selectivity. This paper first introduces the classification and structural characteristics of micro-hotplates. Then the assembly process and characteristics of various gas-sensing materials and micro-hotplates are summarized. Finally, the assembly method of the gas-sensing material and the micro-hotplate prospects.
In this work, a microwave resonator sensor with a unique configuration consisting of three resonators and two feedlines is proposed. This novel design aims to improve the performance and functionality of microwave resonator sensors for various applications. The frequency response of the sensor to materials with different dielectric constants is simulated. The results show that the most sensitive region of the sensor is located on the first interdigital structure, and placing the materials in other regions would enhance the linear correlation of its frequency response. The sensor also exhibits the ability to distinguish whether the same material has defects and the ability to qualitatively detect subtle changes in dielectric constant. Finally, the proposed sensor is fabricated and measured under the condition consistent with the simulation environment. The measured results are basically consistent with the simulation results, which confirms the potential of this sensor in detecting dielectric constants and resolving materials with defects, and the response of the sensor to the materials under test demonstrates its potential in measuring different thicknesses and loss tangents.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.