In this study, the formation and escape movements of a bubble injected in non-Newtonian drilling fluid through a pore were numerically simulated using a volume of fluid method. The pattern of a single bubble and the pressure and velocity fields of the surrounding liquid phase during the bubble formation were analyzed and compared with experimental results; based on the comparison, the formation and escape properties of the bubble were further studied. In particular, the effects of static shear force, consistency coefficient, and flow behavior index on the growth and escape time of the bubble were analyzed. The results show that, owing to the effect of velocity on the viscosity of a non-Newtonian drilling fluid, the escape time and volume of the bubble increase with an increase in static shear force, consistency coefficient, and flow behavior index. Among the three parameters, the flow behavior index has the greatest effect. This is because the shear disturbance of a bubble to its surrounding fluid during its growth and escape, caused by the shear thinning of a yield-power-law fluid, reduces the fluid viscosity. The shear thinning decreases, and the resistance to the bubble increases as the flow behavior index approaches 1, leading to larger bubble formation times and separation volumes. An empirical formula for predicting the equivalent radius of bubbles considering the liquid yield stress, inertial force, viscous force, and surface tension is established. The average error of predicting the equivalent radius of detached bubble is 0.80%, which can provide a reference for the better study of bubble migration and flow pattern in non-Newtonian fluid.
The accurate prediction of wellbore temperature and pressure is important for safe drilling. However, annulus temperature and pressure changes are more complicated due to phase transition. To study this problem, a prediction model of temperature and pressure in deep water riserless drilling is established by considering hydrate cuttings decomposition, interphase mass transfer, and phase transition heat. Based on this model, the effects of hydrate cuttings decomposition on the temperature and pressure of drilling in a hydrate reservoir are explored. The results show that the influence of hydrate cuttings decomposition increases significantly with an increase in the inlet temperature. The influence of hydrate cuttings decomposition on temperature and pressure decreases with an increase in displacement. A small range in the variation of density and penetration rates has little impact on the annulus pressure but mainly affects the temperature. The influence of hydrate cuttings decomposition increases with an increase in the penetration rate. In normal drilling conditions, hydrate cuttings decomposition has little impact on annulus temperature and pressure, but under the conditions of a high inlet temperature, high hydrate saturation, low displacement, and high penetration rate, it is necessary to consider the impact of hydrate cuttings decomposition. This study can provide reference for the prediction of temperature and pressure in deep water hydrate reservoir riserless drilling.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.