Some high-torque electric machines, such as lowspeed wind generators, may be very difficult to test on load because of the large and expensive mechanical equipment required to load them (motors) or to drive them (generators). In this paper, a full-load regenerative testing methodology is described which does not require any rotating equipment to be coupled to the machine where the rated active power flows in a closed loop between the machine and a suitably connected dual-stage converter. The successful application of this methodology to a 780-kW 14-r/min wind generator prototype is addressed as a study case. Relevant experimental results are reported in a companion paper.

No abstract

No abstract

The on-load factory testing of high-power electric machines may be a challenge due to the large mechanical equipment required to drive or load them. In a companion paper, a regenerative full-load testing strategy has been proposed, where the power flows in a closed loop between the electric machine and a dual-stage converter so that only the power corresponding to system losses needs to be supplied by the test facility and no mechanical equipment is needed. In this paper, the implementation of such testing strategy on a 780-kW 14-r/min permanent-magnet alternator with fractional-slot concentrated stator winding is described. Test results are presented and compared with the predictions made in Part I, showing a satisfactory accordance between theoretical and experimental results.

This article reports on the design, development, and validation of advanced prototype 2 MVA generation equipment [i.e., naval package (NP)] for a shipboard medium-voltage dc integrated power system (MVDC IPS). The generation equipment is based on an ultrahigh-speed 22,500-r/min 12-phase alternator, which feeds an ac/dc power electronics converter comprising four diode rectifiers and four insulated-gate bipolar transistor (IGBT) choppers. The prototype realization constitutes a follow-up of a previous NP version employing a wound-field 6,300-r/min alternator feeding noncontrolled ac/dc converters. The major technical challenges faced in the design and development of the advanced NP prototype are outlined in this article, taking the previous lower-speed version as a technology reference. The system performance, as determined by the testing campaign, and lessons learned for future studies are addressed