Mandibular prognathism is a common dentofacial phenotype with a substantial genetic component; however, few susceptibility loci have been mapped. Ethnicity is a risk factor for mandibular prognathism, and a relatively high prevalence is observed in Asian populations. The hypothesis of this study suggested that a specific locus for mandibular prognathism exists in the Han Chinese population. So, the authors studied a Han Chinese pedigree in which mandibular prognathism was inherited (11 affected, 10 unaffected) in an autosomal dominant pattern. A genomewide linkage scan was performed with the Illumina Linkage-12 DNA Analysis Kit. Multipoint parametric and nonparametric linkage analyses were performed with MERLIN 1.01. A susceptibility locus was identified on chromosome 14q24.3-31.2, with a nonparametric linkage score of 11.341 (empirical P = .020) and a logarithm of the odds score of 2.032 (empirical P = .008). Haplotype analysis refined the candidate locus to a 10.62-cM interval (72.42 to 83.14 cM; 74.57 to 84.66 Mb) between rs1468507 and rs7141857. Within this interval, the candidate functional genes are TGFB3 and LTBP2. In conclusion, the authors detected a suggestive linkage for mandibular prognathism in a Han Chinese pedigree, and this finding can be combined with previous studies to further understand the genetic basis of mandibular prognathism.

Mandibular prognathism (MP) is regarded as a craniofacial deformity resulting from the combined effects of environmental and genetic factors, while the genetically predetermined component is considered to play an important role to develop MP. Although linkage and association studies for MP have identified multiple strongly associated regions and genes, the causal genes and variants responsible for the deformity remain largely undetermined. To address this, we performed targeted sequencing of 396 genes selected from previous studies as well as genes and pathways related with craniofacial development as primary candidates in 199 MP cases and 197 controls and carried out a series of statistical and functional analyses. A nonsynonymous common variant of MYO1H rs3825393, C>T, p.Pro1001Leu, was identified to be significantly associated with MP. During zebrafish embryologic development, expression of MYO1H orthologous genes were detected at mandibular jaw. Furthermore, jaw cartilage defects were observed in zebrafish knockdown models. Collectively, these data demonstrate that MYO1H is required for proper jaw growth and contributes to MP pathogenesis, expanding our knowledge of the genetic basis of MP.

NRAGE is a potent regulator of proliferation and odontoblastic differentiation of mDPCs, which might be via the NF-κB signalling pathway.

Temperature is one of the key factors to ensure reliable and efficient performance of proton exchange membrane fuel cells. Whereas, due to the limited cooling capacity in automotive application, conventional strategies may fail to remove the excessive heat when the cooling actuator saturates. Hence, three temperature control strategies based on current constraint are developed in this study. Firstly, a dynamic thermal model based on energy conservation is presented. Then a duty ratio split control strategy is proposed to calculate the reduced current from the excess of duty ratio of radiator, yet spike behavior occurs. Hence, a current governor control strategy and a constrained model predictive control strategy are derived to trade off the power demand and cooling capacity, where the maximum load current is calculated by current governor in real time and optimized under the physical constraints of duty ratio and current change rate, respectively. The performances of all the strategies are demonstrated. The current governor control strategy is easy to implement with less computational burden. The constrained model predictive control strategy has fast response and can take into account various constraints explicitly. Both of them have satisfying control performances regardless of limited cooling capacity.