Bisphenol A (BPA), a chemical compound largely used in the plastics industry, can end up in aquatic systems, which it disturbs by its endocrine disrupting effect (EDE). This study investigated the BPA degradation upon ultrasonic action under different experimental conditions. The effect of saturating gas (oxygen, argon and air), BPA concentration (0.15-460 micromol L(-1)), ultrasonic frequency (300-800 kHz) and power (20-80 W) were evaluated. For a 118 micromol L(-1)-BPA solution, with the best performance obtained at 300 kHz, 80 W, with oxygen as saturating gas. In these conditions, BPA can be readily eliminated by the ultrasound process (approximately 90 min). However, even after long ultrasound irradiation times (9 h), more than 50% of chemical oxygen demand (COD) and 80% of total organic carbon (TOC) remained in the solution. Analyses of intermediates using HPLC-MS investigation identified several products: monohydroxylated bisphenol A, 4-isopropenylphenol, quinone of monohydroxylated bisphenol A, dihydroxylated bisphenol A, quinone of dihydroxylated bisphenol A, monohydroxylated-4-isopropenylphenol and 4-hydroxyacetophenone. The presence of these hydroxylated aromatic structures showed that the main ultrasonic BPA degradation pathway is related to the reaction of BPA with the *OH radical. After 2h, these early products were converted into biodegradable aliphatic acids.
Bisphenol A (BPA), an organic compound largely used in the plastic industry as a monomer for production of epoxy resins and polycarbonate, is an emerging contaminant that is released in the environmentfrom bottles and packaging. BPA degradation (118 micromol L(-1)) under sonochemical conditions was investigated in this study, using a 300 kHz frequency, with a 80 W electrical power. Under these conditions, BPA was eliminated by the ultrasound process (-90 min). However, even after long ultrasound irradiation periods (10 h), more than 50% of chemical oxygen demand (COD) and 80% of total organic carbon (TOC) remained in the solution, indicating that most BPA intermediates are recalcitrant toward ultrasonic action. Accumulation of hydrogen peroxide from *OH and *OOH radical recombination was also observed. To increase the efficiency of BPA treatment, experiments combined ultrasound with Fe2+ (100 micromol L(-1)) and/or UV radiation (254 nm): Ultrasound/UV; Ultrasound/Fe2+; Ultrasound/UV/ Fe2+. Both UV and Fe2+ induced hydrogen peroxide dissociation, leading to additional *OH radicals and complete COD and TOC removal. Thus difficulties in obtaining mineralization of micropollutants like BPA through ultrasonic action alone, can be overcome by the Ultrasound/UV/ Fe2+ combination. Moreover, this technique was found to be the most cost-effective one. So, the integrated ultrasound-UV-iron(ll) process was shown to be of interest for the treatment of wastewaters contaminated with BPA.
Sonochemical elimination of organic pollutants can take place through two degradation pathways. Molecules with relatively large Henry's law constants will be incinerated inside the cavitation bubble, while nonvolatile molecules with low Henry's law constants will be oxidised by the OH(*) ejected from the bubble of cavitation. Taking bisphenol-A as a model pollutant, this study points out an alternate degradation route, mediated by bicarbonate ions, which is significant for the elimination of micro-pollutants at concentrations present in natural waters. In this process, OH(*) radicals react with bicarbonate ions to produce the carbonate radical, which, unlike the OH(*) radical, can migrate towards the bulk of the solution and therefore induce the degradation of the micro-pollutants present in the bulk solution. As a consequence, initial degradation rate is increased by a factor 3.2 at low concentration of bisphenol-A (0.022 micromol l(-1)) in presence of bicarbonate in water.
Acoustic cavitation, induced by ultrasound, can be used to eliminate organic pollutants from water. This type of ultrasonic treatment of polluted water can be grouped with those generally referred to as advanced oxidative processes since it involves hydroxyl radicals. In this case these highly active species are generated from the dissociation of water and oxygen dissociation caused by cavitation bubble collapse. The cavitation induced degradation rates of organic compounds in water are mainly linked to their vapor pressure and solubility and here we will further explore these links by examining the degradation of a mixture of two materials with different physical properties, chlorobenzene and 4-chlorophenol. The results obtained when a dilute solution of a mixture of these compounds saturated with argon is subjected to sonication at 300 kHz, parallels previous observations achieved in an aerated aqueous medium at 500 kHz. The two compounds exhibit sequential degradation with the more volatile chlorobenzene entering the cavitation bubble and being destroyed first. The 4-chlorophenol degradation occurs subsequently only when the chlorobenzene has been completely destroyed. The two compounds exhibit different behavior when sonicated in water saturated with oxygen. Under these conditions the two compounds are degraded simultaneously, a remarkable result for which two explanations can be proposed, both of which are based on the formation of additional OH radical species: The ability to produce conditions for the simultaneous elimination of two organic compounds by the use of oxygen is of great importance in the developing field of ultrasonic water treatment.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.