The fundamental building blocks of digital electronics are logic gates which must be capable of cascading such that more complex logic functions can be realized. Here we demonstrate integrated graphene complementary inverters which operate with the same input and output voltage logic levels, thus allowing cascading. We obtain signal matching under ambient conditions with inverters fabricated from wafer-scale graphene grown by chemical vapor deposition (CVD). Monolayer graphene was incorporated in self-aligned field-effect transistors in which the top gate overlaps with the source and drain contacts. This results in full-channel gating and leads to the highest low-frequency voltage gain reported so far in top-gated CVD graphene devices operating in air ambient, A(v) ∼ -5. Such gain enabled logic inverters with the same voltage swing of 0.56 V at their input and output. Graphene inverters could find their way in realistic applications where high-speed operation is desired but power dissipation is not a concern, similar to emitter-coupled logic.

Ring oscillators (ROs) are the most important class of circuits used to evaluate the performance limits of any digital technology. However, ROs based on low-dimensional nanomaterials (e.g., 1-D nanotubes, nanowires, 2-D MoS2) have so far exhibited limited performance due to low current drive or large parasitics. Here we demonstrate integrated ROs fabricated from wafer-scale graphene grown by chemical vapor deposition. The highest oscillation frequency was 1.28 GHz, while the largest output voltage swing was 0.57 V. Both values remain limited by parasitic capacitances in the circuit rather than intrinsic properties of the graphene transistor components, suggesting further improvements are possible. The fabricated ROs are the fastest realized in any low-dimensional nanomaterial to date and also the least sensitive to fluctuations in the supply voltage. They represent the first integrated graphene oscillators of any kind and can also be used in a wide range of applications in analog electronics. As a demonstration, we also realized the first stand-alone graphene mixers that do not require external oscillators for frequency conversion. The first gigahertz multitransistor graphene integrated circuits demonstrated here pave the way for application of graphene in high-speed digital and analog circuits in which high operating speed could be traded off against power consumption.

A graphene audio voltage amplifier is fabricated by overlapping the gate with source/drain contacts. The fabricated complementary amplifier has a voltage gain of 3.7 (11.4 dB) at 10 kHz, a total harmonic distortion in the audio frequency range of <1%, a unity-gain frequency of 360 kHz, and a −3 dB bandwidth of 70 kHz

Contact resistance is one of the main factors limiting performance of short-channel graphene field-effect transistors (GFETs), preventing their use in low-voltage applications. Here we investigated the contact resistance between graphene grown by chemical vapor deposition (CVD) and different metals, and found that etching holes in graphene below the contacts consistently reduced the contact resistance, down to 23 m with Au contacts. This low contact resistance was obtained at the Dirac point of graphene, in contrast to previous studies where the lowest contact resistance was obtained at the highest carrier density in graphene (here 200 m was obtained under such conditions). The ‘holey’ Au contacts were implemented in GFETs which exhibited an average transconductance of 940 S m−1 at a drain bias of only 0.8 V and gate length of 500 nm, which out-perform GFETs with conventional Au contacts.