Acoustic time-of-flight (ToF) measurements enable noninvasive material characterization, acoustic imaging, and defect detection and are commonly used in industrial process control, biomedical devices, and national security. When characterizing a fluid contained in a cylinder or pipe, ToF measurements are hampered by guided waves, which propagate around the cylindrical shell walls and obscure the waves propagating through the interrogated fluid. We present a technique for overcoming this limitation based on a broadband linear chirp excitation and cross correlation detection. By using broadband excitation, we exploit the dispersion of the guided waves, wherein different frequencies propagate at different velocities, thus distorting the guided wave signal while leaving the bulk wave signal in the fluid unperturbed. We demonstrate the measurement technique experimentally and using numerical simulation. We characterize the technique performance in terms of measurement error, signal-to-noise-ratio, and resolution as a function of the linear chirp center frequency and bandwidth. We discuss the physical phenomena behind the guided bulk wave interactions and how to utilize these phenomena to optimize the measurements in the fluid.
Los Alamos National Laboratory (LANL) has recently developed an ultrasonic side-lobe suppressed Bessel collimated beam transducer for low-frequency imaging through highly attenuating materials. We study the effectiveness of using such a collimated ultrasonic-beam transducer for imaging concrete heterogeneities outside borehole casing for high-resolution borehole imaging and wellbore integrity monitoring. We obtain detailed concrete heterogeneities including a low-velocity zone using ultrasound data acquired with a 3D imaging prototype and our recently developed full-waveform inversion and least-squares reverse-time migration methods. Full-waveform inversion fits synthetic ultrasonic waveforms with recorded waveforms to build a high-resolution velocity model. Least-squares reverse-time migration produces a high-resolution structural image showing material discontinuities. Our results demonstrate that LANL's 3D imaging system with a collimated ultrasonic-beam transducer together with full-waveform inversion and least-squares reverse-time migration imaging has great potential for high-resolution single-well borehole imaging and non-destructive evaluation.
Resonant Ultrasound Spectroscopy was used to determine the elastic moduli of Berea sandstone from room temperature to 478 K. Sandstone is a common component of oil reservoirs, and the temperature range was chosen to be representative of typical downhole conditions, down to about 8 km. In agreement with previous works, Berea sandstone was found to be relatively soft with a bulk modulus of approximately 6 GPa as compared to 37.5 GPa for α‐quartz at room temperature and pressure. It was found that Berea sandstone undergoes a ~17% softening in bulk modulus between room temperature and 385 K, followed by an abnormal behavior of similar stiffening between 385 K and 478 K.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.