This paper describes the experimental validation of two different transient models of the hybrid fuel cell/gas turbine facility of the U.S. DOE-NETL at Morgantown. The first part of this work is devoted to the description of the facility, designed to experimentally investigate these plants with real components, except the fuel cell. The behavior of the SOFC is obtained with apt volumes (for the stack and the off-gas burner) and using a combustor to generate similar thermal effects. The second part of this paper shows the facility real-time transient model developed at the U.S. DOE-NETL and the detailed transient modeling activity using the TRANSEO program developed at TPG. The results obtained with both models are successfully compared with the experimental data of two different load step decreases. The more detailed model agrees more closely with the experimental data, which, of course, is more time consuming than the real-time model (the detailed model operates with a calculation over calculated time ratio around 6). Finally, the TPG model has been used to discuss the importance of performance map precision for both compressor and turbine. This is an important analysis to better understand the steady-state difference between the two models
Fuel cell hybrid power systems have potential for the highest electrical power generation efficiency. Fuel cell gas turbine hybrid systems are currently under development as the first step in commercializing this technology. The dynamic interdependencies resulting from the integration of these two power generation technologies is not well understood. Unexpected complications can arise in the operation of an integrated system, especially during startup and transient events. Fuel cell gas turbine systems designed to operate under steady state conditions have limitations in studying the dynamics of a transient event without risk to the more fragile components of the system. A 250kW experimental fuel cell gas turbine system test facility has been designed at the National Energy Technology Laboratory (NETL), U.S. Department of Energy to examine the effects of transient events on the dynamics of these systems. The test facility will be used to evaluate control strategies for improving system response to transient events and load following. A fuel cell simulator, consisting of a natural gas burner controlled by a real time fuel cell model, will be integrated into the system in place of a real solid oxide fuel cell. The use of a fuel cell simulator in the initial phases allows for the exploration of transient events without risk of destroying an actual fuel cell. Fuel cell models and hybrid system models developed at NETL have played an important role in guiding the design of facility equipment and experimental research planning. Results of certain case studies using these models are discussed. Test scenarios were analyzed for potential thermal and mechanical impact on fuel cell, heat exchanger and gas turbine components. Temperature and pressure drop calculations were performed to determine the maximum impact on system components and design. Required turbine modifications were designed and tested for functionality. The resulting facility design will allow for examination of startup, shut down, loss of load to the fuel cell during steady state operations, loss of load to the turbine during steady state operations and load following.
Hybrid fuel cell/gas turbine (FC/GT) systems have been shown through experiment and simulation to be highly efficient technologies with low emissions. Maintaining efficient, low emission, and safe operation, whether during disturbances or regular operational transients, is a challenge to both understand and address. Some likely disturbances can arise from changes in ambient temperature, fuel flow variations induced by supply pressure disturbances, fuel composition variability, and power demand fluctuations.To gain insight into the dynamic operation of such cycles and address operating challenges, dynamic modeling tools have been developed at two different laboratories. In this paper these models are used to simulate the dynamic operation of an integrated MCFC/GT hybrid system and to subsequently develop and test control strategies for the hybrid power plant. Two control strategies are developed and tested for their ability to control the system during various perturbations. Predicted fuel cell operating temperature, fuel utilization, fuel cell and GT power, shaft speed, compressor mass flow and temperatures throughout the FC/GT system are presented for the controlled response to a fuel cell voltage increase in order to show the effect of a load decrease.
This paper describes some generic solid oxide and molten carbonate hybrid fuel cell gas turbine systems and dynamic modeling tools that are being developed to simulate the performance of these and other hybrid fuel cell systems. The generic hybrid systems are presented to introduce issues and technical development challenges that hybrid fuel cell gas turbine systems must address and to provide a platform for the development of the dynamic modeling tools. The present goals are to develop dynamic models for the basic components of solid oxide and molten carbonate fuel cell gas turbine hybrids, ensure their reliability, and obtain a basic understanding of their performance prior to integration into a complete hybrid system model. Preliminary results for molten carbonate and solid oxide fuel cell types are presented. These results provide understanding of some of the operational characteristics of fuel cells, and indicate the complexity of the dynamic response of fuel cell hybrid components. For the fuel cell models, generic planar designs are analyzed showing voltage and current behavior following step changes in load resistance and steady state performance curves. The results provide confidence in each of the model’s reliability, enabling them to be integrated for hybrid system simulation. Results from the integrated simulations will provide guidance on future hybrid technology development needs.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.