No abstract

Abstract-Radiometric measurements of the microwave emissivity of foam were conducted during May 2000 at the Naval Research Laboratory's Chesapeake Bay Detachment using radiometers operating at 10.8 and 36.5 GHz. Horizontal and vertical polarization measurements were performed at 36.5 GHz; horizontal, vertical, +45 , 45 , left-circular, and right-circular polarization measurements were obtained at 10.8 GHz. These measurements were carried out over a range of incidence angles from 30 to 60 . Surface foam was generated by blowing compressed air through a matrix of gas-permeable tubing supported by an aluminum frame and floats. Video micrographs of the foam were used to measure bubble size distribution and foam layer thickness. A video camera was boresighted with the radiometers to determine the beam-fill fraction of the foam generator. Results show emissivities that were greater than 0.9 and approximately constant in value over the range of incidence angles for vertically polarized radiation at both 10.8 and 36.5 GHz, while emissivities of horizontally polarized radiation showed a gradual decrease in value as incidence angle increased. Emissivities at +45 , 45 , left-circular, and right-circular polarizations were all very nearly equal to each other and were in turn approximately equal to the average values of the horizontal and vertical emissivities in each case.

Abstract-Radiometric measurements of the microwave emissivity of foam were conducted during May 2000 at the Naval Research Laboratory's Chesapeake Bay Detachment using radiometers operating at 10.8 and 36.5 GHz. Horizontal and vertical polarization measurements were performed at 36.5 GHz; horizontal, vertical, +45 , 45 , left-circular, and right-circular polarization measurements were obtained at 10.8 GHz. These measurements were carried out over a range of incidence angles from 30 to 60 . Surface foam was generated by blowing compressed air through a matrix of gas-permeable tubing supported by an aluminum frame and floats. Video micrographs of the foam were used to measure bubble size distribution and foam layer thickness. A video camera was boresighted with the radiometers to determine the beam-fill fraction of the foam generator. Results show emissivities that were greater than 0.9 and approximately constant in value over the range of incidence angles for vertically polarized radiation at both 10.8 and 36.5 GHz, while emissivities of horizontally polarized radiation showed a gradual decrease in value as incidence angle increased. Emissivities at +45 , 45 , left-circular, and right-circular polarizations were all very nearly equal to each other and were in turn approximately equal to the average values of the horizontal and vertical emissivities in each case.

No abstract

A novel analytical method is presented for evaluating the electrical performance of a radome for a dual-polarized phased-array antenna under rain conditions. Attenuation, reflections, and induced cross polarization are evaluated for different rainfall conditions and radome types. The authors present a model for estimating the drop size distribution on a radome surface based on skin surface material, area, inclination, and rainfall rate. Then, a multilayer radome model based on the transmission-line-equivalent circuit model is used to characterize the radome’s scattering parameters. Numerical results are compared with radar data obtained in the Next Generation Weather Radar (NEXRAD) and Collaborative Adaptive Sensing of the Atmosphere (CASA) systems, and good agreement is found.

No abstract

No abstract

No abstract