No abstract

No abstract

An acoustic reverberator consisting of a network of delay lines connected via scattering junctions is proposed. All parameters of the reverberator are derived from physical properties of the enclosure it simulates. It allows for simulation of unequal and frequency-dependent wall absorption, as well as directional sources and microphones. The reverberator renders the first-order reflections exactly, while making progressively coarser approximations of higher-order reflections. The rate of energy decay is close to that obtained with the image method (IM) and consistent with the predictions of Sabine and Eyring equations. The time evolution of the normalized echo density, which was previously shown to be correlated with the perceived texture of reverberation, is also close to that of IM. However, its computational complexity is one to two orders of magnitude lower, comparable to the computational complexity of a feedback delay network (FDN), and its memory requirements are negligible

This paper is concerned with an acoustical phenomenon called sweeping echo, which manifests itself in a room impulse response as a distinctive, continuous pitch increase. In this paper, it is shown that sweeping echoes are present (although to greatly varying degrees) in all perfectly rectangular rooms. The theoretical analysis is based on the rigid-wall image solution of the wave equation. Sweeping echoes are found to be caused by the orderly time-alignment of high-order reflections arriving from directions close to the three axial directions. While sweeping echoes have been previously observed in real rooms with a geometry very similar to the rectangular model (e.g. a squash court), they are not perceived in commonly encountered rooms. Room acoustic simulators such as the image method (IM) and finitedifference time-domain (FDTD) correctly predict the presence of this phenomenon, which means that rectangular geometries should be used with caution when the objective is to model commonly encountered rooms. Small out-of-square asymmetries in the room geometry are shown to reduce the phenomenon significantly. Randomization of the image sources' position is shown to remove sweeping echoes without the need to model an asymmetrical geometry explicitly. Finally, the performance of three speech and audio processing algorithms is shown to be sensitive to strong sweeping echoes, thus highlighting the need to avoid their occurrence. I. INTRODUCTION S PEECH and audio processing research studies often require a room acoustic model that is representative of common acoustical conditions. A simplified model of room geometry that is often used in the literature is the perfectly

Abstract-This paper presents a systematic framework for the analysis and design of circular multichannel surround sound systems. Objective analysis based on the concept of active intensity fields shows that for stable rendition of monochromatic plane waves it is beneficial to render each such wave by no more than two channels. Based on that finding, we propose a methodology for the design of circular microphone arrays, in the same configuration as the corresponding loudspeaker system, which aims to capture inter-channel time and intensity differences that ensure accurate rendition of the auditory perspective. The methodology is applicable to regular and irregular microphone/speaker layouts, and a wide range of microphone array radii, including the special case of coincident arrays which corresponds to intensity-based systems. Several design examples, involving first and higher-order microphones are presented. Results of formal listening tests suggest that the proposed design methodology achieves a performance comparable to prior art in the center of the loudspeaker array and a more graceful degradation away from the center.Index Terms-Active intensity, microphone array, microphone directivity, multichannel audio, spatial hearing, surround sound recording, tangent panning law, time-intensity trading.

Abstract-Developments in immersive audio technologies have been evolving in two directions: physicallymotivated and perceptually-motivated systems. Physically motivated techniques aim to reproduce a physically accurate approximation of desired sound fields by employing a very high equipment load and sophisticated computationally intensive algorithms. Perceptually-motivated techniques, on the other hand, aim to render only the perceptually relevant aspects of the sound scene by means of modest computational and equipment load. This article presents an overview of perceptually motivated techniques, with a focus on multichannel audio recording and reproduction, audio source and reflection culling, and artificial reverberators.

It is known that applying a time-frequency binary mask to very noisy speech can improve its intelligibility but results in poor perceptual quality. In this paper we propose a new approach to applying a binary mask that combines the intelligibility gains of conventional binary masking with the perceptual quality gains of a classical speech enhancer. The binary mask is not applied directly as a time-frequency gain as in most previous studies. Instead, the mask is used to supply prior information to a classical speech enhancer about the probability of speech presence in different time-frequency regions. Using an oracle ideal binary mask, we show that the proposed method results in a higher predicted quality than other methods of applying a binary mask whilst preserving the improvements in predicted intelligibility

No abstract