Hybrid machine tools combining additive and subtractive processes have arisen as a solution to increasing manufacture requirements, boosting the potentials of both technologies, while compensating and minimizing their limitations. Nevertheless, the idea of hybrid machines is relatively new and there is a notable lack of knowledge about the implications arisen from their in-practice use. Therefore, the main goal of the present paper is to fill the existing gap, giving an insight into the current advancements and pending tasks of hybrid machines both from an academic and industrial perspective. To that end, the technical-economical potentials and challenges emerging from their use are identified and critically discussed. In addition, the current situation and future perspectives of hybrid machines from the point of view of process planning, monitoring, and inspection are analyzed. On the one hand, it is found that hybrid machines enable a more efficient use of the resources available, as well as the production of previously unattainable complex parts. On the other hand, it is concluded that there are still some technological challenges derived from the interaction of additive and subtractive processes to be overcome (e.g., process planning, decision planning, use of cutting fluids, and need for a post-processing) before a full implantation of hybrid machines is fulfilled.

At present, airframes are mainly composed of monolithic components, instead of small parts joined using welding or riveting. Ribs, stringers, spars, and bulkheads can be included in this category. After milling, they are assembled and joined to the aircraft skins, which have also been milled. The aim of these parts is to obtain a good strength-weight ratio, owing to their homogeneity. The milling of a monolithic structural part implies removing up to 95 per cent of the weight from the raw block material. Therefore, the main objective is to achieve the highest removal rate possible. However, conditions required to achieve this (high feed, large depth of cut) in milling imply high cutting forces, which in turn induce part deflection or vibrations in those zones (thin walls and floors) where stiffness is not sufficiently high. These static and dynamic problems often lead to inaccuracy of geometry, roughness, and possible damage to the machine spindle. This paper proposes a working methodology for efficient process planning, based on previous analysis of the static and dynamic phenomena that can occur during high-speed cutting. This methodology provides several steps that can be taken in order to minimize the bending and vibration effects; suggests optimal monitoring methods to detect process instability; and describes the best way to tune the cutting conditions and chip load, by means of simulation at different machining stages. In this way, the reliability of aeronautical production significantly increases. The global approach presented in this paper has been applied to two test pieces and two real parts, which were milled without suffering either static or dynamic problems.

No abstract

No abstract

No abstract

Hot stamping dies include cooling channels to treat the formed sheet. The optimum cooling channels of dies and molds should adapt to the shape and surface of the dies, so that a homogeneous temperature distribution and cooling are guaranteed. Nevertheless, cooling ducts are conventionally manufactured by deep drilling, attaining straight channels unable to follow the geometry of the tool. Laser Metal Deposition (LMD) is an additive manufacturing technique capable of fabricating nearly free-form integrated cooling channels and therefore shape the so-called conformal cooling. The present work investigates the design and manufacturing of conformal cooling ducts, which are additively built up on hot work steel and then milled in order to attain the final part. Their mechanical performance and heat transfer capability has been evaluated, both experimentally and by means of thermal simulation. Finally, conformal cooling conduits are evaluated and compared to traditional straight channels. The results show that LMD is a proper technology for the generation of cooling ducts, opening the possibility to produce new geometries on dies and molds and, therefore, new products.

No abstract

No abstract