Differential thermal analysis (DTA) was used to study the crystallization phenomena in Y2O3‐Al2O3 fibers formed via a melt extraction process. Such fibers are X‐ray amorphous and optically transparent regardless of composition in the as‐extracted state but can be crystallized to produce various equilibrium phases that depend on the original composition of the ceramic rods used in the extraction process. The activation energy values were calculated using Kissinger and Augis‐Bennett equations by measuring the variation of the peak temperature in the differential thermal patterns with heating rate. X‐ray diffractometry analysis was used to determine the phase formation in the fibers crystallized after the DTA scan.
A method for the fabrication of interconnected ceramic sponges was used in the present work, designed by using a combination of two different, aqueous gel casting and sacrificial template, using aluminum nitride powder (99.97%) with a mean size of 2.4 micrometers. Two types of sponges were made by using two different monomers, acrylamide and methacrylamide, the resultants sponges have 60% of porosity after being sintered and pyrolyzed at temperature of 1673 K using an inert atmosphere of argon for 1 h. The hydrolysis evolution of this ceramic powder during the gelcasting process was studied by measuring the pH during the stirring time, the microstructure changes during the time of exposure were observed in a SEM. XRD were made to study the present phases after the gel was eliminated by thermal treatment at 873 K using an oxidizing atmosphere, observing a formation of up to 4 %wt. of cubic alumina phase which was made after the hydrolysis products. Infrared spectroscopy was used to study the changes in the ceramic powder.
The work presents an electrochemical study of the corrosion behaviour of two TiC/Cu-Ni metal matrix composites with a content of 10 and 20 wt.% Ni immersed in synthetic seawater. The composites were synthesized by a capillary infiltration technique, obtaining dense materials TiC/Cu-10Ni and TiC/Cu-20 Ni with a residual porosity of 1.8 and 1.7%, respectively. The corrosion rate (CR) was evaluated from the techniques of polarization curves (PC), linear polarization resistance (LPR) and electrochemical impedance spectroscopy (EIS). Electrochemical measurements were carried out under static conditions, ambient temperature and atmospheric pressure at 24 hours exposure in the electrolytic medium. The corrosion rate is affected by the Ni content in the matrix, with less corrosion in the composite with a higher Ni content. The higher content of Ni in the Cu-Ni alloy provides higher passivation and stability to the corrosion products film that are absorbed on the composite surface. Microscopic examination (SEM) showed a characteristic morphology of a corrosion mechanism of the localized type (pits and crevices) generated by a differential aeration, where the TiC/Cu-10Ni composite showed greater degradation.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.