Morphological, geochemical and mineralogical studies were carried out in a representative soil catena of the low-elevation plateaux of the upper Amazon Basin to interpret the steps and mechanisms involved in the podzolization of low-activity clay soils. The soils are derived from Palaeozoic sandstones. They consist of Hydromorphic Podzols under tree savannah in the depressions of the plateaux and predominantly of Acrisols covered by evergreen forest elsewhere.Incipient podzolization in the uppermost Acrisols is related to the formation of organic-rich A and Bhs horizons slightly depleted in fine-size particles by both mechanical particle transfer and weathering. Weathering of secondary minerals by organic acids and formation of organo-metallic complexes act simultaneously over short distances. Their vertical transfer is limited. Selective dissolution of aluminous goethite, then gibbsite and finally kaolinite favour the preferential cheluviation of first Fe and secondly Al. The relatively small amount of organo-metallic complexes produced is related to the quartzitic parent materials, and the predominance of Al over Fe in the spodic horizons is due to the importance of gibbsite in these low-activity clay soils.Morphologically well-expressed podzols occur in strongly iron-depleted topsoils of the depression. Mechanical transfer and weathering of gibbsite and kaolinite by organic acids is enhanced and leads to residual accumulation of sands. Organo-metallic complexes are translocated in strongly permeable sandy horizons and impregnate at depth the macro-voids of embedded soil and saprolite materials to form the spodic Bs and 2BCs horizons. Mechanical transfer of black particulate organic compounds devoid of metals has occurred later within the sandy horizons of the podzols. Their vertical transfer has formed well-differentiated A and Bh horizons. Their lateral removal by groundwater favours the development of an albic E horizon. In an open and waterlogged environment, the general trend is therefore towards the removal of all the metals that have initially accumulated as a response to the ferralitization process and have temporarily been sequestrated in organic complexes in previous stages of soil podzolization.

Although several laboratory studies showed that Mn-oxides are capable of oxidizing Cr(II) to Cr(VI), very few have reported evidence for such a reaction in natural systems. This study presents new evidence for this redox reaction between Cr(III) and Mn-oxides in a lateritic regolith developed on ultramafic rocks in New Caledonia. The studied lateritic regolith presents several units with contrasting amounts of major (Fe, Al, Si, and Mg) and trace (Mn, Cr, Ni, Co) elements, which are related to varying mineralogical compositions. Bulk XANES analyses show the occurrence of Cr(VI) (up to 20 wt % of total chromium) in the unit of the regolith which is also enriched in Mn (up to 21.7 wt % MnO), whereas almost no Cr(VI) is detected elsewhere. X-ray powder diffraction indicates that the large amounts of Mn in this unit of the regolith are due to the occurrence of Mn-oxides (identified as a mixture of asbolane, lithiophorite and birnessite) and Mn K-edge XANES data indicate that Mn occurs mainly as Mn(IV) in this unit, although small amounts of Mn(III) could also be detected. These results strongly suggest a direct role of the Mn-oxides on the occurrence of Cr(VI) through a redox reaction between Cr(III) and Mn(IV) and/or Mn(III). Owing to the much larger toxicity and solubility of Cr(VI), such a co-occurrence of Cr and Mn-oxides in these soils could then represent an important risk for the environment. However, the significant amounts of Cr(VI) released after reacting the samples from the studied sequence with a 0.1 M (NH)4H2PO4 solution, designed to remove tightly sorbed chromate species, suggest that Cr(VI) mainly occurs as sorption complexes. This hypothesis is reinforced by spatially resolved XANES analyses, which show that Cr(VI) is associated with both Mn- and Fe-oxides, and especially at the boundary between these two mineral species. Such a distribution of Cr(VI) suggests a possible readsorption of Cr(VI) onto surrounding Fe-oxyhydroxides (mainly goethite) after oxidation by the Mn(IV)-oxides. These results, added to leaching tests with a 0.01 M CaCl2 solution indicative of low exchangeability of Cr in the investigated samples, suggest that secondary sorption reactions onto Fe-oxides might significantly decrease the environmental impact of the oxidation of Cr(III) to Cr(VI) by Mn-oxides.

No abstract

The nature of pigments in naturally colored pearls is still under discussion. For this study, Raman scattering measurements were obtained for 30 untreated freshwater cultured pearls from the mollusk Hyriopsis cumingi covering their typical range of colors. The originality of this work is that seven different excitation wavelengths (1064 nm, 676.44 nm, 647.14 nm, 514.53 nm, 487.98 nm, 457.94 nm, 363.80 nm) are used for the same samples at the highest possible resolution. All colored pearls show the two major Raman features of polyenic compounds assigned to double carbon-carbon (C C) -at about 1500 cm −1 -and single carbon-carbon (C-C) -at about 1130 cm −1 -bond stretching mode, regardless of their specific hue. These peaks are not detected in the corresponding white pearls, and therefore seem directly related to the major cause of body color. Additionally, the exact position of C C stretching vibration shows that these compounds are not members of the carotenoid family. Moreover, some changes are observed in intensities, shape and positions of the two main characteristic polyenic peaks from one sample to the next. Similar changes are observed also using several excitation wavelengths for the same point of the same pearl. The exact position of C-C stretching vibration of polyenic molecules depends strongly on the number of double bonds (N) contained in their polyenic chain. Hence, using a constrained decomposition of this band for different excitation wavelengths, up to nine different pigments may be detected in the same pearl. Their general chemical formula is R-(-CH CH-) N -R with N = 6-14. All our colored samples contained at least four pigments (N = 8-11). Different colors are explained by different mixtures, not by a simple change of pigment. The chemical nature of the chain ends is still unknown, because it cannot be detected with Raman scattering. However, it is possible that these polyenes are complexed with carbonate molecules of the nacre. Similar coloration mechanisms are found in products from other living organisms (e.g. parrots feathers). Moreover, it seems that a similar series of pigments is found in other pearls also, as well as in some marine animals living in similar environments (e.g. corals).

No abstract

No abstract

International audienceSeventy-seven gem opals from ten countries were analyzed by inductively coupled plasma-mass spectrometry (ICP-MS) through a dilution process, in order to establish the nature of the impurities. The results are correlated to the mode of formation and physical properties and are instrumental in establishing the geographical origin of a gem opal. The geochemistry of an opal is shown to be dependant mostly on the host rock, at least for examples from Mexico and Brazil, even if modified by weathering processes. In order of decreasing concentration, the main impurities present are Al, Ca, Fe, K, Na, and Mg (more than 500 ppm). Other noticeable elements in lesser amounts are Ba, followed by Zr, Sr, Rb, U, and Pb. For the first time, geochemistry helps to discriminate some varieties of opals. The Ba content, as well as the chondritenormalized REE pattern, are the keys to separating sedimentary opals (BaN110 ppm, Eu and Ce anomalies) from volcanic opals (Bab110 ppm, no Eu or Ce anomaly). The Ca content, and to a lesser extent that of Mg, Al, K and Nb, helps to distinguish gem opals from different volcanic environments. The limited range of concentrations for all elements in precious (play-of-color) compared to common opals, indicates that this variety must have very specific, or more restricted, conditions of formation. We tentatively interpreted the presence of impurities in terms of crystallochemistry, even if opal is a poorly crystallized or amorphous material. The main replacement is the substitution of Si4+ by Al3+ and Fe3+. The induced charge imbalance is compensated chiefly by Ca2+, Mg2+, Mn2+, Ba2+, K+, and Na+. In terms of origin of color, greater concentrations of iron induce darker colors (from yellow to "chocolate brown"). This element inhibits luminescence for concentrations above 1000 ppm, whereas already a low content in U (=1 ppm) induces a green luminescence

The exact nature of pigments present in cultured freshwater pearls is still not well known. We examined 21 untreated cultured freshwater pearls from Hyriopsis of typical colors by diffuse reflectance UV-Vis-NIR and Raman scattering measurements, at high resolution. The objective was to establish the relation between color and the nature of the pigment mixture in pearls, using strictly non-destructive methods. All natural color samples show the two major Raman resonance features of unmethylated (unsubstituted) polyenes, not carotenoids. Their general chemical formulae are R-(-CH¼CH) N-R 0 with N ¼ 6 to 14 and they give absorptions from violet to yellow-green. Each color is due to a mixture of pigments, not a single pigment. Different colors are explained by different mixtures. Each pigment identified by Raman spectroscopy can be related to a specific absorption with apparent maximum in the range 405-568 nm, thus absorbing from violet to yellow-green. This is the first study of the precise relation between Raman and diffuse reflectance spectra of cultured freshwater pearls.