Epitaxial GaN layers were synthesised by PA MBE on Si (111) with and without using the high-temperature nitridation. We performed a complete investigation of their structural and optical properties. It was proven that the presence of GaN epitaxial layer less than a micrometer leads to the appearance of tensile stress in the structure. The stress was calculated and compared for the structure with nitridation and without it. The effect of nitridation on holes density was also observed by Raman spectroscopy and Hall measurements.
The problem of optimizing the topography of metal structures allowing Surface Enhanced Raman Scattering (SERS) sensing is considered. We developed a model, which randomly distributes hemispheroidal particles over a given area of the glass substrate and estimates SERS capabilities of the obtained structures. We applied Power Spectral Density (PSD) analysis to modeled structures and to atomic force microscope images widely used in SERS metal island films and metal dendrites. The comparison of measured and calculated SERS signals from differing characteristics structures with the results of PSD analysis of these structures has shown that this approach allows simple identification and choosing a structure topography, which is capable of providing the maximal enhancement of Raman signal within a given set of structures of the same type placed on the substrate.
It is shown for the first time that the vacuum poling of soda-lime silicate glass and the subsequent processing of the glass in a melt containing silver ions results in the formation of silver nanoparticles buried in the subanodic region of the glass at a depth of 800–1700 nm. We associate the formation of nanoparticles with the transfer of electrons from negatively charged non-bridging oxygen atoms to silver ions, their reduction as well as their clustering. The nanoparticles do not form in the ion-depleted area just beneath the glass surface, which indicates the absence of a spatial charge (negatively charged oxygen atoms) in this region of the vacuum-poled glass. In consequence, the neutralization of the glass via switching of non-bridging oxygen bonds to bridging ones, which leads to the release of oxygen, should occur in parallel with the shift of calcium, magnesium, and sodium ions into the depth of the glass.
We demonstrate for the first time that the results of ion exchange processing of thermally poled soda-lime glass essentially depend on the poling conditions. In particular, the processing of vacuum-poled soda-lime glass in silver-sodium nitrate melt results in the diffusion and reduction of silver ions followed by clustering silver nanoparticles in the subsurface layer of the glass after either ion-exchange or additional heat treatment of the ion-exchanged samples. Poling in air atmosphere with deposited gold film anode prevents silver ions penetration in the glass, but electric field stimulated diffusion of gold in this configuration leads to the formation of gold nanoparticles in the glass after heat treatment. It is also shown that corona poling of the glass in air atmosphere does not completely block silver penetration.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.