The 5 th generation (5G) of mobile radio access technologies is expected to become available for commercial launch around 2020. In this paper, we present our envisioned 5G system design optimized for small cell deployment taking a clean slate approach, i.e. removing most compatibility constraints with the previous generations of mobile radio access technologies. This paper mainly covers the physical layer aspects of the 5G concept design.I.

Ultra-dense small cells are foreseen to play an essential role in the 5 th generation (5G) of mobile radio access technology, which will be operating over different bands with respect to established systems. The natural step for exploring new spectrum is to look into the centimeter-wave bands as well as exploring millimeter-wave bands. This paper presents our vision on the technology components for a 5G centimeter-wave concept for ultra-dense small cells. Fundamental features such as optimized short frame structure, multi-antenna technologies, interference rejection, rank adaptation and dynamic scheduling of uplink/downlink transmission are discussed, along with the design of a novel flexible waveform and energy-saving enablers.I.

Coordinated multipoint (CoMP) transmission and reception have been considered in cellular networks for enabling larger coverage, improved rates, and interference mitigation. To harness the gains of coordinated beamforming, fast information exchange over a backhaul connecting the cooperating base stations (BSs) is required. In practice, the bandwidth and delay limitations of the backhaul may not be able to meet such stringent demands. These impairments motivate the study of cooperative approaches based only on local channel state information (CSI) and which require minimal or no information exchange between the BSs. To this end, several distributed approaches are introduced for coordinated beamforming (CB)-CoMP. The proposed methods rely on the channel reciprocity and iterative spatially precoded over-the-air pilot signaling. We elaborate how forwardbackward (F-B) training facilitates distributed CB by allowing BSs and user equipments (UEs) to iteratively optimize their respective transmitters/receivers based on only locally measured CSI. The trade-off due to the overhead from the F-B iterations is discussed. We also consider the challenge of dynamic TDD where the UE-UE channel knowledge cannot be acquired at the BSs by exploiting channel reciprocity. Finally, standardization activities and practical requirements for enabling the proposed F-B training schemes in 5G radio access are discussed.

A next generation Beyond 4G (B4G) radio access technology is expected to become available around 2020 in order to cope with the exponential increase of mobile data traffic. In this paper, research motivations and high level requirements for a B4G local area concept are discussed. Our suggestions on the design of the B4G system as well as on the choice of its key technology components are also presented.

No abstract

No abstract

The ideal radio waveform for an upcoming 5 th Generation (5G) radio access technology should cope with a set of requirements such as limited complexity, good time/frequency localization and simple extension to multi-antenna technologies. This paper discusses the suitability of Orthogonal Frequency Division Multiplexing (OFDM) and its recently proposed enhancements as 5G waveforms, mainly focusing on their capability to cope with our requirements. Significant focus is given to the novel zero-tail paradigm, which allows boosting the OFDM flexibility while circumventing demerits such as poor spectral containment and sensitivity to hardware impairments. I.978-1-4799-4482-8/14/$31.00 ©2014 IEEE

No abstract