The effect of the surface chemistry of DNA recognition interfaces on DNA hybridization at a gold surface was investigated using both electrochemistry and the quartz crystal microbalance (QCM) technique. Different DNA recognition interfaces were prepared using a two-component self-assembled monolayer consisting of thiolated 20-mer probe single-stranded DNA (ss-DNA) containing either a 3'-mercaptopropyl or a 3'-mercaptohexyl linker group and an alcohol-terminated diluent layer with 2-, 6-, or 11-carbon length. The influence of the interfacial design on the hybridization efficiency, the affinity constant (Ka) describing hybridization, and the kinetics of hybridization was assessed. It was found that the further the DNA was above the surface defined by the diluent layer the higher the hybridization efficiency and Ka. The kinetics of DNA hybridization was assessed using both a QCM and an electrochemical approach to ascertain the influence of the interface on both the initial binding of target DNA to the surface and the formation of a complete duplex. These measurements showed that the length of the diluent layer has a large impact on the time taken to form a perfect duplex but no impact on the initial recognition of the target DNA by the immobilized probe DNA.
To provide a comprehensive understanding of the field effect in silicon nanowire (SiNW) sensors, we take a systematic approach to fine tune the distance of a charge layer by controlling the hybridization sites of DNA to the SiNW preimmobilized with peptide nucleic acid (PNA) capture probes. Six target DNAs of the same length, but differentiated successively by three bases in the complementary segment, are hybridized to the PNA. Fluorescent images show that the hybridization occurs exclusively on the SiNW surface between the target DNAs and the PNA. However, the field-effect response of the SiNW sensor decreases as the DNA (charge layer) moves away from the SiNW surface. Theoretical analysis shows that the field effect of the SiNW sensor relies primarily on the location of the charge layer. A maximum of 102% change in resistance is estimated based on the shortest distance of the DNA charge layer (4.7 A) to the SiNW surface.
A DNA hybridization biosensor based on long-range electron transfer that is capable of detecting DNA single-base mismatch is presented. A mixed self-assembled monolayer of single-stranded DNA (ss-DNA), thiolated at the 3' end, and 6-mercapto-1-hexanol was formed on a gold surface. This probe ss-DNA-modified gold surface was incubated in 2,6-disulfonic acid anthraquinone (AQDS) intercalator solution, rinsed, and placed in an AQDS-free buffer solution, whereupon voltammetric experiments were performed. No voltammetric peaks were observed for probe ss-DNA-modified gold electrodes. Upon DNA hybridization and incubation in AQDS, clear voltammetric peaks, consistent with the oxidation and reduction of AQDS, were observed. The absence of AQDS electrochemistry for ss-DNA-modified surfaces clearly shows the electrochemistry is due to long-range electron transfer through the DNA duplex. No peak currents were observed when the probe ss-DNA-modified surface was exposed to noncomplementary target DNA, but there was a diminution in current signal upon hybridization with C-A mismatched and a G-A mismatched targets.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.