AbstrakMakalah ini menjelaskan penggunaan pemodelan CFD untuk menganalisis kenyamanan termal di perusahaan pengisian minyak pelumas yang memiliki luas 3000 m 2 . Kebutuhan akan analisis ini berasal dari kondisi yang tidak nyaman yang dirasakan oleh para pekerja perusahaan. Simulasi 3D menggunakan perangkat lunak FLUENT 6.3.26 dilakukan untuk menganalisis distribusi suhu dan kecepatan di ruang pabrik. Air diasumsikan sebagai fluida ideal yang tidak dapat dimampatkan, aliran yang stabil, model turbulensi yang digunakan standar k-ε, algoritma SIMPLE dan diskritisasi arah angin kedua. Analisis dilakukan pada model yang ada dan mengusulkan model, dimana pada model usulan, diffuser dipasang di atas pekerja dengan ketinggian 4,2 m di atas lantai, kecepatan suplai udara diffuser bervariasi dari 1,5 m/s , 2 m/s, dan 2,5 m/s. Hasil simulasi menunjukkan bahwa distribusi suhu dalam kondisi yang ada di kisaran sekitar 34-36°C, nilai ini melebihi standar kenyamanan termal yang ditentukan oleh ASHRAE.Hasil simulasi menunjukkan bahwa model yang diusulkan distribusi suhu yang lebih baik, di mana suhu dihasilkan dalam kisaran kriteria kenyamanan termal ASHRAE, mulai dari 24-26°C, dan kecepatan udara pasokan di inlet diffuser 1,5 m/s direkomendasikan untuk digunakan dalam sistem AHU. Untuk 20 unit diffuser dengan kecepatan inlet 1,5 m/s, laju aliran massa yang harus ditangani oleh perangkat pendingin adalah 9 kg/s dan membutuhkan kapasitas pendinginan 0,128 MW. Ini 58% lebih efisien daripada mendinginkan seluruh ruangan perusahaan. AbstractThis paper describes the use of CFD modeling to analyze the thermal comfort in the oil filling factory which has an area of 3000 m 2 . The need for this analysis comes from an uncomfortable condition that is felt by the workers of the factory. A 3D simulation using FLUENT software 6.3.26 conducted to analyze the temperature and velocity distribution in the plant room. The water is assumed as an incompressible ideal gas, steady flow, turbulence models used k ε standard, the SIMPLE algorithm and second order upwind discretisation. Analysis was conducted on existing models and propose models, whereby on a model propose, the diffuser is installed above the workers with a height of 4,2 m above the floor, the velocity of supply air diffuser is varied from 1,5 m/s, 2 m/s, and 2,5 m/s. The simulation results show that the temperature distribution in the existing conditions in the range of about 34-36°C, this value exceeds the thermal comfort standards specified by ASHRAE.The simulation results show that the proposed model better temperature distribution, where the temperature is generated in the range of ASHRAE thermal comfort criteria, ranging from 24-26°C, and the supply air velocity at the diffuser inlet of 1,5 m/s recommended for use in AHU 30 Volume 1 No 2 tahun 2019
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.