A simple, stiff, statically and dynamically stable linear oscillator incorporating a negative stiffness element is used as a template to provide a generic theoretical basis for a novel vibration damping and isolation concept. This oscillator is designed to present the same overall static stiffness, the same mass and to use the same damping element as a reference classical linear SDoF oscillator. Thus, no increase of the structure mass or the viscous damping is needed, as in the case of a traditional linear isolator, no decrease of the overall structure stiffness is required as in the case of 'zero-stiffness' oscillators with embedded negative stiffness elements. The difference from these two templates consists entirely in the proper redistribution and reallocation of the stiffness and the damping elements of the system. Once such an oscillator is optimally designed, it is shown to exhibit an extraordinary apparent damping ratio, which is even several orders of magnitude higher than that of the original SDoF system, especially in cases where the original damping of the SDoF system is extremely low. This extraordinary damping behavior is a result of the phase difference between the positive and the negative stiffness elastic forces, which is in turn a consequence of the proper redistribution of the stiffness and the damping elements. This fact ensures that an adequate level of elastic forces exists throughout the entire frequency range, able to counteract the inertial and the excitation forces. Consequently, a resonance phenomenon, which is inherent in the original linear SDoF system, cannot emerge in the proposed oscillator. The optimal parameter selection for the design of the negative stiffness oscillator is discussed. To further exhibit the advantages that such a design can generate, the suggested oscillator is implemented within a periodic acoustic metamaterial structure, inducing a radical increase in the damping of the propagating acoustic waves. The concept may find numerous technological applications, either as traditional vibration isolators, or within advanced composite materials and metamaterials.
A seat that provides good vibration isolation is of prime importance for passenger’s safety and health. The main conflict in seat suspensions implies that the increasing initial deformation of the system (increase in “static discomfort”) leads to better isolation of accelerations (increase in “dynamic comfort”). Many researchers have focused on overcoming or at least suppressing this conflict between load support capacity and vibration isolation by modeling new suspension systems, such as the so-called negative suspension systems. However, apart from the modeling of new suspension systems, optimization is an important part in designing a seat and finding the best compromise between these two objectives. Thus, in this work, four types of seat suspension systems with embedded negative stiffness elements are implemented and optimized in order to be benchmarked. Three of them have already been tested either in passenger or in an off-road vehicle seat. All the vibration isolators are optimized with genetic algorithms in respect to static and dynamic factors of ride comfort by applying constraints oriented to the objectives and the design of the structure. The optimization is implemented for two excitations, which correspond to a vehicle driving over road profiles of Classes A and B, and the common solutions are outlined.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.