No abstract

A novel synthesis process of ZIF-94 (also known as SIM-1) is developed for particle size tuning, using either NaOH or NH4OH as deprotonators. ZIF-94 stem from MOFs and have several...

The application of proton-exchange membrane fuel cells (PEMFCs) in maritime transportation is currently in the spotlight due to stringent emissions regulations and the establishment of a carbon trading system. However, salt in the marine environment can accelerate the degradation of proton-exchange membranes (PEM), which are the core component of PEMFCs. In this study, the effect of the NaCl concentration and temperature on the degradation of Nafion, the benchmark PEMFC membrane, was analyzed ex situ by accelerated degradation using Fenton’s test. The membrane properties were studied by mass change, fluoride ion emission, FTIR spectroscopy, and tensile test. The results showed that the degradation of Nafion membranes increased with the increase in temperature and NaCl concentration. Further studies revealed that Nafion produces C=O bonds during the degradation process. Additionally, it was found that sodium ions replace hydrogen ions in degraded Nafion fragments based on analysis of the weight change, and the rate of substitution increases with increasing temperature. A better understanding of the degradation behavior of Nafion in salty environments will lead to the advanced manufacturing of PEM for applications of PEMFCs in maritime transportation.

No abstract

No abstract

No abstract

No abstract

The complete flax stem, which contains shives and technical fibres, has the potential to reduce the cost, energy consumption and environmental impacts of the composite production process if used directly as reinforcement in a polymer matrix. Earlier studies have utilised flax stem as reinforcement in non-bio-based and non-biodegradable matrices not completely exploiting the bio-sourced and biodegradable nature of flax. We investigated the potential of using flax stem as reinforcement in a polylactic acid (PLA) matrix to produce a lightweight, fully bio-based composite with improved mechanical properties. Furthermore, we developed a mathematical approach to predict the material stiffness of the full composite part produced by the injection moulding process, considering a three-phase micromechanical model, where the effects of local orientations are accounted. Injection moulded plates with a flax content of up to 20 V% were fabricated to study the effect of flax shives and full straw flax on the mechanical properties of the material. A 62% increase in longitudinal stiffness was obtained, resulting in a 10% higher specific stiffness, compared to a short glass fibre-reinforced reference composite. Moreover, the anisotropy ratio of the flax-reinforced composite was 21% lower, compared to the short glass fibre material. This lower anisotropy ratio is attributed to the presence of the flax shives. Considering the fibre orientation in the injection moulded plates predicted with Moldflow simulations, a high agreement between experimental and predicted stiffness data was obtained. The use of flax stems as polymer reinforcement provides an alternative to the use of short technical fibres that require intensive extraction and purification steps and are known to be cumbersome to feed to the compounder.