It is important that efficient measures to reduce the airborne transmission of respiratory infectious diseases (including COVID-19) should be formulated as soon as possible to ensure a safe easing of lockdown. Ventilation has been widely recognized as an efficient engineering control measure for airborne transmission. Room ventilation with an increased supply of clean outdoor air could dilute the expiratory airborne aerosols to a lower concentration level. However, sufficient increase is beyond the capacity of most of the existing mechanical ventilation systems that were designed to be energy efficient under non-pandemic conditions. We propose an improved control strategy based on source control, which would be achieved by implementing intermittent breaks in room occupancy, specifically that all occupants should leave the room periodically and the room occupancy time should be reduced as much as possible. Under the assumption of good mixing of clean outdoor supply air with room air, the evolution of the concentration in the room of aerosols exhaled by infected person(s) is predicted. The risk of airborne cross-infection is then evaluated by calculating the time-averaged intake fraction. The effectiveness of the strategy is demonstrated for a case study of a typical classroom. This strategy, together with other control measures such as continuous supply of maximum clean air, distancing, face-to-back layout of workstations and reducing activities that increase aerosol generation (e.g., loudly talking and singing), is applicable in classrooms, offices, meeting rooms, conference rooms, etc.

No abstract

People are the main reason for the deterioration of indoor air quality (IAQ) due to the continuous physiological metabolism processes in their bodies, including respiration. We present results from an investigation of the influence of indoor air temperature on the concentration of exhaled carbon dioxide (CO2). The investigation was preconditioned by previous findings on the effect of air temperature on human metabolism. However, our literature survey showed a lack of studies on the influence of the indoor air temperature on the exhaled CO2 (or metabolic CO2), which leads to the novelty of our results. Our experiments had two phases: measurement in a university classroom with an installed heating, ventilation, and air-conditioning (HVAC) system during regular classes and measurement in a specially designed small climate chamber, where the time variations of the CO2 concentrations, together with some physiological parameters, were measured. Two indoor air temperatures were set: 23 °C and 27 °C. The results obtained and their respective analyses show the strong effect of the two air temperatures on the CO2 concentration due to exhalation. In the classroom, the CO2 concentration at 27 °C was higher by 6.2% than at 23 °C. In the climate chamber, the CO2 concentration at 27 °C was higher by 9.6% than at 23 °C. Physiological parameters (oxygen saturation pressure, pulse rate, end-tidal CO2, and respiration rate) and their dependence on the air temperature were also measured in the climate chamber, establishing an effect of the temperature on the pulse rate.

The present ventilation design practice as well as the ventilation standards and building regulations are based on the assumption for complete mixing of air in occupied spaces. Required flow rate of outdoor air for dilution of metabolic CO2 generated by occupants is calculated to keep the CO2 concentration below certain required level. The CO2 concentration measured in the exhaust air or in the room but far from the occupants is assumed to be the same as the CO2 concentration in the air inhaled by the occupants. However, this assumption is seldom accurate, especially in spaces with closely seated occupants, such as classrooms, meeting rooms, etc. In such spaces the CO2 sources, i.e. the people, are close to each other and the CO2 concentration in the inhaled air may be much above the CO2 concentration level recommended as a limit in standards. This is because the upward free convection flow that exists around human body entrains the air with high CO2 concentration exhaled by seated people and move it to their breathing zone. Furthermore, the thermal flows generated by occupants’ body interact with the ventilation flow, which often results in insufficient dilution of the generated CO2 (as well as other pollution) and high levels of CO2 concentration at the breathing zone of occupants. This problem is discussed in the present paper in detail. The discussion is supported by results of measurements in a meeting room with mixing air distribution. People were used to generate metabolic CO2 and a breathing thermal manikin was used to measure accurately the CO2 concentration in the inhaled air. The results confirmed that inhaled CO2 concentration was much higher than the one at the exhaust and that there is need for changes in the present CO2 based ventilation design practice. Possible solutions are suggested.

No abstract

No abstract

No abstract

The thermal environment in an indoor space is determined by the thermal state of the human body, and the local thermal discomfort. The draught rate (DR) is one of the indices for thermal discomfort. The achievement of air distribution without draught is one of the goals of the ventilation methods. It is especially important in the design of climate chambers, where the volume is small, and the research studies may require prolonged occupants’ exposure. Our study shows results from the CFD simulations of a mechanically ventilated climate chamber, performed in the design stage of the chamber’s construction. Velocity profiles distribution, temperature distribution and DR are used to assess the thermal comfort of the person in the chamber. The results obtained allowed designing of the proper indoor environment with desired characteristics for air distribution and human exposure.