Effects of the addition of hemp fiber particles on the compressive and flexural behaviors of an industrially important amorphous thermoplastic, Acrylonitrile-Butadiene-Styrene (ABS), were investigated for the first time in this study. Particles with a size of 67–500 μm were first extracted from 10% NaOH alkaline-treated hemp fibers, and then incorporated into ABS at three various weight ratios (1wt%, 5wt% and 10wt%). Compression and three-point bending tests results revealed that both the compressive and flexural modulus of ABS increase with increasing particle content, but its compressive post-yield and flexural strengths decrease as enhancing particle content. The test results also showed that increasing particle content results in a significant improvement in the compressive modulus of ABS, but a slight enhancement in its flexural modulus. The notch-impact test results revealed that the impact strength of ABS is adversely affected by the incorporation of hemp fiber particles. The FT-IR (Fourier Transform Infrared Spectroscopy) analysis results indicated that mechanical bonding is formed between matrix and natural particles rather than chemical bonding. The SEM (Scanning Electron Microscopy) results put forth that the observed decrease in both the compressive post-yield and flexural strength is mainly due to the lack of strong mechanical bonding between ABS and particles. The three-point bending test data of the materials were satisfactorily reproduced using the linear Drucker-Prager material model in Abaqus engineering software.
In this paper, the dynamic performance of two parallel micro-cantilever beams is investigated and the results are presented. The dynamic response is of high interest in MEMS structures as it is related to the performance of the micro-devices. The micro-cantilever beams can be easily fabricated and yield high sensitivity to variations of physical quantities. In this work, the dynamic response of two parallel flexible cantilever beams subjected to a difference of potential is analyzed. This configuration was modeled as mass-damper spring systems with two degrees of freedom. Such a system can be used to measure the viscosity of liquids. This viscosity is related to damping between two masses representing the two beams in the discrete system model. The fabrication of two identical beams using MEMS fabrication processes may be difficult as the fabrication process may yield some variabilities. Thus, the two beams may be slightly different which will be reflected in their mass and stiffness. This condition was assumed in the proposed model. As the system is sensitive to the applied difference of potential such that the pull-in voltage represents a good indicator of the sensitivity performance. The dynamic analysis was carried out at potentials close to the pull-in value. Stability of the system was evaluated and the responses of the beams were calculated at a potential close to the pull-in voltage. The sensitivity of the system was calculated for different viscosities of liquid between two beams. It was found that an increase of the viscosity yields higher nonlinearity and consequently loose of accuracy while assuming linear stiffness for the beams. In this research, the stiffness of micro-cantilever beams was calculated from small deflection theory of beams. However, there are other methods that could be considered to evaluate the stiffness of the beams. One of this different methods was considered and the sensitivity of the modeled stiffness is discussed. Since the stiff nonlinear differential equations cannot be solved analytically, the numerical approach was exploited. In this work ISODE method from Maple software was used to solve the model described by the two differential equations.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.