No abstract

Programming the synthesis and self-assembly of molecules is a compelling strategy for the bottom-up fabrication of ordered materials. To this end, shape-persistent macrocycles were designed with alternating carbazoles and triazoles to program a one-pot synthesis and to bind large anions. The macrocycles bind anions that were once considered too weak to be coordinated, such as PF6 (-) , with surprisingly high affinities (β2 =10(11)  M(-2) in 80:20 chloroform/methanol) and positive cooperativity, α=(4 K2 /K1 )=1200. We also discovered that the macrocycles assemble into ultrathin films of hierarchically ordered tubes on graphite surfaces. The remarkable surface-templated self-assembly properties, as was observed by using scanning tunneling microscopy, are attributed to the complementary pairing of alternating triazoles and carbazoles inscribed into both the co-facial and edge-sharing seams that exist between shape-persistent macrocycles. The multilayer assembly is also consistent with the high degree of molecular self-association observed in solution, with self-association constants of K=300 000 M(-1) (chloroform/methanol 80:20). Scanning tunneling microscopy data also showed that surface assemblies readily sequester iodide anions from solution, modulating their assembly. This multifunctional macrocycle provides a foundation for materials composed of hierarchically organized and nanotubular self-assemblies.

Covalent organic frameworks (COFs) are highly modular porous crystalline polymers that are of interest for applications such as charge‐storage devices, nanofiltration membranes, and optoelectronic devices. COFs are typically synthesized as microcrystalline powders, which limits their performance in these applications, and their limited solubility precludes large‐scale processing into more useful morphologies and devices. We report a general, scalable method to exfoliate two‐dimensional imine‐linked COF powders by temporarily protonating their linkages. The resulting suspensions were cast into continuous crystalline COF films up to 10 cm in diameter, with thicknesses ranging from 50 nm to 20 μm depending on the suspension composition, concentration, and casting protocol. Furthermore, we demonstrate that the film fabrication process proceeds through a partial depolymerization/repolymerization mechanism, providing mechanically robust films that can be easily separated from their substrates.

Two-dimensional (2D) covalent organic frameworks (COFs) are composed of structurally precise, permanently porous, layered macromolecular sheets, which are traditionally synthesized as polycrystalline solids with crystalline domain lengths smaller than 100 nm. Here, we polymerize imine-linked 2D COFs as suspensions of faceted single crystals in as little as 5 min at moderate temperature and ambient pressure. Single crystals of two imine-linked 2D COFs were prepared, consisting of a rhombic 2D COF (TAPPy-PDA) and a hexagonal 2D COF (TAPB-DMPDA). The sizes of TAPPy-PDA and TAPB-DMPDA crystals were tuned from 720 nm to 4 μm and 450 nm to 20 μm in width, respectively. High-resolution transmission electron microscopy revealed that the COF crystals consist of layered, 2D polymers comprising single-crystalline domains. Continuous rotation electron diffraction resolved the unit cell and crystal structure of both COFs, which are single-crystalline in the a–b plane but disordered in the stacking c dimension. Single crystals of both COFs were incorporated into gas chromatography separation columns and exhibited unusual selective retention of cyclohexane over benzene, with single-crystalline TAPPy-PDA significantly outperforming single-crystalline TAPB-DMPDA. Polycrystalline TAPPy-PDA exhibited no separation, while polycrystalline TAPB-DMPDA exhibited poor separation and the opposite order of elution, retaining benzene more than cyclohexane, indicating the importance of improved material quality for COFs to exhibit properties that derive from their precise, crystalline structures. This work represents the first example of synthesizing imine-linked 2D COF single crystals at ambient pressure and short reaction times and demonstrates the promise of high-quality COFs for molecular separations.

Covalent organic framework (COF) membranes are of great promise for energy-efficient separations. Thick, polycrystalline COF films have been reported to separate dyes, salts, bacteria, and nanoparticles on the basis of size-selective transport through ordered pores. Here, we show that these materials function as adsorbents, not as size-sieving membranes. Binding isotherms of several dyes typical of the COF membrane literature to three COF powder samples illustrate that COFs are high-capacity adsorbents with affinities that span a range of 3 orders of magnitude, trends which map onto previously reported separation behavior. Computational results suggest that observed differences in adsorption can be correlated to variable entropic gains driving the adsorption process. Polycrystalline COF pellets show volume-dependent and flow-rate dependent “rejection” of dyes, consistent with an adsorption-based removal mechanism. Previous reports of thick, polycrystalline COF membranes used low flow rates and small dye volumes to probe rejection capabilities, where membrane and adsorbent behavior is not distinguishable. A mixed dye separation experiment in flow shows affinity-dependent performance. These results necessitate a careful reexamination of the COF membrane literature, as separations based on differential transport through 2D COF pores remain an important yet unrealized frontier.

Covalent organic frameworks (COFs) are highly modular porous crystalline polymers that are of interest for applications such as charge‐storage devices, nanofiltration membranes, and optoelectronic devices. COFs are typically synthesized as microcrystalline powders, which limits their performance in these applications, and their limited solubility precludes large‐scale processing into more useful morphologies and devices. We report a general, scalable method to exfoliate two‐dimensional imine‐linked COF powders by temporarily protonating their linkages. The resulting suspensions were cast into continuous crystalline COF films up to 10 cm in diameter, with thicknesses ranging from 50 nm to 20 μm depending on the suspension composition, concentration, and casting protocol. Furthermore, we demonstrate that the film fabrication process proceeds through a partial depolymerization/repolymerization mechanism, providing mechanically robust films that can be easily separated from their substrates.

Two‐dimensional covalent organic frameworks (2D COFs) are attractive candidates for next‐generation membrane active layers due to their robust linkages and uniform, tunable pores. Many publications have claimed to achieve selective molecular transport through 2D COF membranes, but reported performance metrics for similar networks vary dramatically, and in several cases the reported experiments are inadequate to support such conclusions. These issues require a reevaluation of the literature. Published examples of 2D COF membranes for liquid‐phase separations can be broadly divided into two categories, each with common performance characteristics: polycrystalline COF films (most >1 μm thick) and weakly crystalline or amorphous films (most <500 nm thick). The former exhibit high solvent permeance, and most, if not all, function as selective adsorbents rather than membranes. The latter behave as membranes with lower permeance in line with conventional reverse osmosis and nanofiltration membranes but have amorphous or ambiguous long‐range order that precludes conclusions about separations occurring via selective transport through the COF pores. So far, neither category has demonstrated consistent relationships between the designed COF pore structure and separation performance, suggesting that these imperfect materials do not sieve molecules through uniform pores. In this perspective, we describe rigorous characterization practices that should be applied to both COF membrane structure and separation performance, which will facilitate their development toward molecularly precise membranes capable of performing previously unrealized chemical separations. In the absence of this more rigorous standard of proof, reports of COF‐based membranes should be treated with skepticism. As methods to control 2D polymerization and 2D polymer processing improve, we anticipate that precise 2D polymer membranes will exhibit exquisite and energy efficient performance relevant for contemporary separation challenges.This article is protected by copyright. All rights reserved

Two-dimensional covalent organic frameworks (2D COFs) containing heterotriangulenes have been theoretically identified as semiconductors with tunable, Dirac-cone-like band structures, which are expected to afford high charge-carrier mobilities ideal for next-generation flexible electronics. However, few bulk syntheses of these materials have been reported, and existing synthetic methods provide limited control of network purity and morphology. Here, we report transimination reactions between benzophenone-imine-protected azatriangulenes (OTPA) and benzodithiophene dialdehydes (BDT), which afforded a new semiconducting COF network, OTPA-BDT. The COFs were prepared as both polycrystalline powders and thin films with controlled crystallite orientation. The azatriangulene nodes are readily oxidized to stable radical cations upon exposure to an appropriate p-type dopant, tris(4-bromophenyl)ammoniumyl hexachloroantimonate, after which the network’s crystallinity and orientation are maintained. Oriented, hole-doped OTPA-BDT COF films exhibit electrical conductivities of up to 1.2 × 10–1 S cm–1, which are among the highest reported for imine-linked 2D COFs to date.