The choice of a dual-polymerizable cement should be based on its intended use because not all products polymerize adequately in every clinical situation. Although no cement met the stated criteria for an "all-purpose" cement, those tested did produce a range of product-specific results.

The aim of this study was to evaluate the features of dentinal tubules occlusion following application of three commercially available desensitizing agents: potassium oxalate-based / Oxa-Gel (OX), HEMA and glutaraldehyde-based / Gluma Desensitizer (GD) and acidulated phosphate fluoride-based / Nupro Gel (AF). Buccal cervical areas of twenty-four extracted human third molars were smoothed and wet-polished with SiC papers and diamond pastes, in order to simulate the clinical aspect of hypersensitive dentin cervical surfaces. The teeth were randomly divided into four groups (n=6), according to the dentin surface treatments: G1: untreated; G2: OX; G3: GD; G4: AF. Specimens were fractured in the lingual-buccal direction and prepared for SEM analysis. OX promoted tubule occlusion by crystal-like deposits in the lumen of the tubules. While GL created a thin layer over the dentin surface, AF application produced precipitates that occluded the tubules. According to the SEM analysis, all desensitizing agents were able to occlude the dentinal tubules.

No abstract

No abstract

This study evaluated bonding of adhesives to dentin treated with silver diammine fluoride (SDF). Micro-shear bond strength (MSBS) to sound human dentin was investigated for 3 adhesive systems: Clearfil SE bond 2 (CSE), and Scotchbond Universal in self-etching (SBU) and phosphoric acid-etching (SBT) modes, following 4 different SDF application protocols (n=10); Control: treated with deionized water. P1: SDF applied for 10-s, no rinse. P2: SDF applied for 10-s, rinsed off after 1-min. P3: superficial dentin polished off after 24-h following P1. MSBS data were obtained after 24-h water storage at 37°C. SDF significantly affected MSBS to dentin depending on the SDF protocol and adhesive system. Rinsing SDF off improved bond strength but superficial refreshing of SDFtreated dentin prior to bonding showed the highest bond strength. The two-step self-etch adhesive (CSE) and the universal adhesive in acid-etching mode (SBT) showed better performance than universal adhesive (SBU) alone on SDF treated dentin.