Ambient noise tomography has proven to be effective in resolving shallow earth structure. We applied ambient noise tomography on a dense seismic array in Long Beach, California. The array was composed of more than 5200 stations with an average spacing close to 100 m. Three weeks of passive ambient noise were crosscorrelated between each station pair, which resulted in more than 13.5 million crosscorrelations within the area. Clear fundamental-mode Rayleigh waves were observed between 0.5 and 4 Hz, which were most sensitive to structure above 1-km depth. For each station pair, we applied frequency-time analysis to determine the phase traveltime dispersion, and, for each frequency, we applied eikonal tomography to determine the Rayleigh wave phase velocity map. The eikonal tomography accounted for ray bending by tracking the wavefront and allowed uncertainties to be estimated through statistical analysis. The compilation of phase velocity maps was then used to invert for 3D shear velocity structure. The inverted model showed clear correlation with the known geologic features such as the shallow south-north velocity dichotomy and a deeper fast anomaly associated with the NewportInglewood fault zone. Our results can potentially be used to complement traditional active source studies.

HadUK‐Grid is a new dataset of gridded climate observations for the UK produced by the Met Office Hadley Centre for Climate Science and Services. The dataset interpolates in situ observations to a regular grid using methods developed in a previous equivalent dataset that had been made available to users since 2002 through the UK Climate Projections project (UKCIP02, UKCP09). The new dataset differs from the existing one in a number of key respects: higher spatial resolution, longer time series for some variables, improved consistency with regard to the pre‐processing of station observations, the use of publicly‐accessible ancillary data sources, a revised calculation sequence for some variables and improved version control. This makes for a dataset that is more internally consistent, more traceable and more reproducible. The result is a dataset of key UK climate variables of up to 1 km resolution from 1862 for monthly rainfall, 1884 for monthly temperature, 1891 for daily rainfall, 1929 for monthly sunshine and a wider set of variables with start dates from the 1960s to support the need for national climate monitoring and climate research.

We discuss several outstanding aspects of seismograms recorded during >4 weeks by a spatially dense Nodal array, straddling the damage zone of the San Jacinto fault in southern California, and some example results. The waveforms contain numerous spikes and bursts of high-frequency waves (up to the recorded 200 Hz) produced in part by minute failure events in the shallow crust. The high spatial density of the array facilitates the detection of 120 small local earthquakes in a single day, most of which not detected by the surrounding ANZA and regional southern California networks. Beamforming results identify likely ongoing cultural noise sources dominant in the frequency range 1-10 Hz and likely ongoing earthquake sources dominant in the frequency range 20-40 Hz. Matched-field processing and back-projection of seismograms provide alternate event location. The median noise levels during the experiment at different stations, waves generated by Betsy gunshots, and wavefields from nearby earthquakes point consistently to several structural units across the fault. Seismic trapping structure and local sedimentary basin produce localized motion amplification and stronger attenuation than adjacent regions. Cross correlations of high-frequency noise recorded at closely spaced stations provide a structural image of the subsurface material across the fault zone. The high spatial density and broad frequency range of the data can be used for additional high resolution studies of structure and source properties in the shallow crust.

We develop a novel method for seismic event detection that can be applied to large-N arrays. The method is based on a new detection function named local similarity, which quantifies the signal consistency between the examined station and its nearest neighbors. Using the 5200-station Long Beach nodal array, we demonstrate that stacked local similarity functions can be used to detect seismic events with amplitudes near or below noise levels. We apply the method to one-week continuous data around the 03/11/2011 Mw 9.1 Tohoku-Oki earthquake, to detect local and distant events. In the 5–10 Hz range, we detect various events of natural and anthropogenic origins, but without a clear increase in local seismicity during and following the surface waves of the Tohoku-Oki mainshock. In the 1-Hz low-pass-filtered range, we detect numerous events, likely representing aftershocks from the Tohoku-Oki mainshock region. This high-resolution detection technique can be applied to both ultra-dense and regular array recordings for monitoring ultra-weak micro-seismicity and detecting unusual seismic events in noisy environments.

No abstract

SUMMARY The Groningen gas field is one of the largest gas fields in Europe. The continuous gas extraction led to an induced seismic activity in the area. In order to monitor the seismic activity and study the gas field many permanent and temporary seismic arrays were deployed. In particular, the extraction of the shear wave velocity model is crucial in seismic hazard assessment. Local S-wave velocity-depth profiles allow us the estimation of a potential amplification due to soft sediments. Ambient seismic noise tomography is an interesting alternative to traditional methods that were used in modelling the S-wave velocity. The ambient noise field consists mostly of surface waves, which are sensitive to the Swave and if inverted, they reveal the corresponding S-wave structures. In this study, we present results of a depth inversion of surface waves obtained from the cross-correlation of 1 month of ambient noise data from four flexible networks located in the Groningen area. Each block consisted of about 400 3-C stations. We compute group velocity maps of Rayleigh and Love waves using a straight-ray surface wave tomography. We also extract clear higher modes of Love and Rayleigh waves. The S-wave velocity model is obtained with a joint inversion of Love and Rayleigh waves using the Neighbourhood Algorithm. In order to improve the depth inversion, we use the mean phase velocity curves and the higher modes of Rayleigh and Love waves. Moreover, we use the depth of the base of the North Sea formation as a hard constraint. This information provides an additional constraint for depth inversion, which reduces the S-wave velocity uncertainties. The final S-wave velocity models reflect the geological structures up to 1 km depth and in perspective can be used in seismic risk modelling.

No abstract

SUMMARY We develop a new method to monitor and locate seismic velocity changes in the subsurface using seismic noise interferometry. Contrary to most ambient noise monitoring techniques, we use the ballistic Rayleigh waves computed from 30 d records on a dense nodal array located above the Groningen gas field (the Netherlands), instead of their coda waves. We infer the daily relative phase velocity dispersion changes as a function of frequency and propagation distance with a cross-wavelet transform processing. Assuming a 1-D velocity change within the medium, the induced ballistic Rayleigh wave phase shift exhibits a linear trend as a function of the propagation distance. Measuring this trend for the fundamental mode and the first overtone of the Rayleigh waves for frequencies between 0.5 and 1.1 Hz enables us to invert for shear wave daily velocity changes in the first 1.5 km of the subsurface. The observed deep velocity changes (±1.5 per cent) are difficult to interpret given the environmental factors information available. Most of the observed shallow changes seem associated with effective pressure variations. We observe a reduction of shear wave velocity (–0.2 per cent) at the time of a large rain event accompanied by a strong decrease in atmospheric pressure loading, followed by a migration at depth of the velocity decrease. Combined with P-wave velocity changes observations from a companion paper, we interpret the changes as caused by the diffusion of effective pressure variations at depth. As a new method, noise-based ballistic wave passive monitoring could be used on several dynamic (hydro-)geological targets and in particular, it could be used to estimate hydrological parameters such as the hydraulic conductivity and diffusivity.