In JET, both high density and low-q operation are limited by disruptions. The density limit disruptions are caused initially by impurity radiation. This causes a contraction of the plasma temperature profile and leads to an MHD unstable configuration. There is evidence of magnetic island formation resulting in minor disruptions. After several minor disruptions, a major disruption with a rapid energy quench occurs. This event takes place in two stages. In the first stage there is a loss of energy from the central region. In the second stage there is a more rapid drop to a very low temperature, apparently due to a dramatic increase in impurity radiation. The final current decay takes place in the resulting cold plasma. During the growth of the MHD instability the initially rotating mode is brought to rest. This mode locking is believed to be due to an electromagnetic interaction with the vacuum vessel and external magnetic field asymmetries. The low-q disruptions are remarkable for the precision with which they occur at qψ = 2. These disruptions do not have extended precursors or minor disruptions. The instability grows and locks rapidly. The energy quench and current decay are generally similar to those of the density limit.

Results are presented from a series of dedicated experiments carried out on JET in tritium, DT, deuterium and hydrogen plasmas to determine the dependence of the H mode power threshold on the plasma isotopic mass. The Pthr ∝ Aeff-1 scaling is established over the whole isotopic range. This result makes it possible for a fusion reactor with a 50:50 DT mixture to access the H mode regime with about 20% less power than that needed in a DD mixture. Results on the first systematic measurements of the power necessary for the transition of the plasma to the type I ELM regime, which occurs after the transition to H mode, are also in agreement with the Aeff-1 scaling. For a subset of discharges, measurements of Te and Ti at the top of the profile pedestal have been obtained, indicating a weak influence of the isotopic mass on the critical edge temperature thought to be necessary for the H mode transition.

Analysis of MHD activity in pellet enhanced performance (PEP) pulses is used to determine the position of rational surfaces associated with the safety factor q. This gives evidence for negative shear in the central region of the plasma. The plasma equilibrium calculated from the measured q values yields a Shafranov shift in reasonable agreement with the experimental value of about 0.2 m. The corresponding current profile has two large off-axis maxima in agreement with the bootstrap current calculated from the electron temperature and density measurements. A transport simulation shows that the bootstrap current is driven by the steep density gradient, which results from improved confinement in the plasma core where the shear is negative. During the PEP phase (m,n)=(1,1) fast MHD events are correlated with collapses in the neutron rate. The dominant mode preceding these events usually is n=3, whereas the mode following them is dominantly n=2. Toroidal linear MHD stability calculations assuming a non-monotonic q-profile with an off-axis minimum decreasing from above 1 to below 1 describe this sequence of modes (n=3,1,2), but always give a larger growth rate for the n=1 mode than for the n=2 mode. This large growth rate is due to the high central poloidal beta of 1.5 observed in the PEP pulses. Finally, a rotating (m,n)=(1,1) mode is observed as a hot spot with a ballooning character on the low field side. The hot spot has some of the properties of a 'hot' island consistent with the presence of a region of negative shear

No abstract

The scaling of the energy confinement in H-mode plasmas with different hydrogenic isotopes (H, D, D-T and T) is investigated in JET. For ELM-free H-modes the thermal energy confinement time τ th is found to decrease weakly with the isotope mass (τ th ~ M-0.25 ± 0.22) whilst in ELMy H-modes the energy confinement time shows practically no mass dependence (τ th ~ M 0.03 ± 0.1). Detailed local transport analysis of the ELMy H-mode plasmas reveals that the confinement in the edge region increases strongly with the isotope mass whereas the confinement in the core region decreases with mass (τ thcore ∝ M-0.16) in approximate agreement with theoretical models of the gyro-Bohm type (τ gB ~ M-0.2).

An experiment has been performed at the Joint European Torus (JET) which has demonstratedclear self-heating of a deuterium-tritium plasma by alpha particles produced in fusion reactions. Since the alpha power was approximately 10% of the total power absorbed by the plasma, the heating was distinguished from other changes, due to isotopic effects, by scanning the plasma and neutral beam mixtures together from pure D to nearly pure T in a hot ion H-mode with 10.5MW neutral beam power. At an optimum mixture of 60±20% T, the fusion gain (=P fusion / P absorbed ) was 0.65 and the alpha heating showed clearly as a maximum in electron temperature.

Detailed studies of sawtooth activity in Ohmic plasmas in JET have revealed significant discrepancies both with previously reported observations of the phenomenon and with conventional models of the internal disruption. ‘Compound’ sawteeth, which display an intermediate collapse during the ramp phase, are observed in the majority of discharges. These usually exhibit no precursor activity, in contrast to observations in smaller tokamaks, but are often accompanied by successor oscillations. Furthermore, the collapse time of such sawteeth is much shorter than expected. These results suggest that the conventional model of the sawtooth is inadequate to explain sawtooth activity in large tokamaks.

No abstract