After many years of fusion research, the conditions needed for a D–T fusion reactor have been approached on the Tokamak Fusion Test Reactor (TFTR) [Fusion Technol. 21, 1324 (1992)]. For the first time the unique phenomena present in a D–T plasma are now being studied in a laboratory plasma. The first magnetic fusion experiments to study plasmas using nearly equal concentrations of deuterium and tritium have been carried out on TFTR. At present the maximum fusion power of 10.7 MW, using 39.5 MW of neutral-beam heating, in a supershot discharge and 6.7 MW in a high-βp discharge following a current rampdown. The fusion power density in a core of the plasma is ≊2.8 MW m−3, exceeding that expected in the International Thermonuclear Experimental Reactor (ITER) [Plasma Physics and Controlled Nuclear Fusion Research (International Atomic Energy Agency, Vienna, 1991), Vol. 3, p. 239] at 1500 MW total fusion power. The energy confinement time, τE, is observed to increase in D–T, relative to D plasmas, by 20% and the ni(0) Ti(0) τE product by 55%. The improvement in thermal confinement is caused primarily by a decrease in ion heat conductivity in both supershot and limiter-H-mode discharges. Extensive lithium pellet injection increased the confinement time to 0.27 s and enabled higher current operation in both supershot and high-βp discharges. Ion cyclotron range of frequencies (ICRF) heating of a D–T plasma, using the second harmonic of tritium, has been demonstrated. First measurements of the confined alpha particles have been performed and found to be in good agreement with TRANSP [Nucl. Fusion 34, 1247 (1994)] simulations. Initial measurements of the alpha ash profile have been compared with simulations using particle transport coefficients from He gas puffing experiments. The loss of alpha particles to a detector at the bottom of the vessel is well described by the first-orbit loss mechanism. No loss due to alpha-particle-driven instabilities has yet been observed. D–T experiments on TFTR will continue to explore the assumptions of the ITER design and to examine some of the physics issues associated with an advanced tokamak reactor.

Wall conditioning in the Tokamak Fusion Test Reactor ͑TFTR͒ ͓K. M. McGuire et al., Phys. Plasmas 2, 2176 ͑1995͔͒ by injection of lithium pellets into the plasma has resulted in large improvements in deuterium-tritium fusion power production ͑up to 10.7 MW͒, the Lawson triple product ͑up to 10 21 m Ϫ3 s keV͒, and energy confinement time ͑up to 330 ms͒. The maximum plasma current for access to high-performance supershots has been increased from 1.9 to 2.7 MA, leading to stable operation at plasma stored energy values greater than 5 MJ. The amount of lithium on the limiter and the effectiveness of its action are maximized through ͑1͒ distributing the Li over the limiter surface by injection of four Li pellets into Ohmic plasmas of increasing major and minor radius, and ͑2͒ injection of four Li pellets into the Ohmic phase of supershot discharges before neutral-beam heating is begun.

Alpha particle loss was measured during the TFTR DT experiments with a scintillator detector located at the vessel bottom in the ion Del B drift direction. The DT alpha particle loss to this detector was consistent with the calculated first orbit loss over the whole range of plasma current I=0.6-2.7 MA. In particular, the alpha particle loss rate per DT neutron at a given plasma current did not increase significantly with fusion power up to 10.7 MW, indicating the absence of any new 'collective' alpha particle loss processes in these experiments

No abstract

Portions of this document may be illegible in electronic image products. Images are produced from the best available original document.

The Tokamak Fusion Test Reactor (TFTR) is a large tokamak which has performed experiments with 50:50 deuterium-tritium fuelled plasmas. Since 1993, TFTR has produced about 1090 D-T plasmas using about 100 grams of tritium and producing about 1.6 GJ of D-T fusion energy. These plasmas have significant populations of 3.5 MeV alphas (the charged D-T fusion product). TFTR research has focused on alpha particle confinement, alpha driven modes, and alpha heating studies. Maximum D-T fusion power production has aided these studies, requiring simultaneously operation at high input heating power and large energy confinement time (to produce the highest temperature and density), while maintaining low impurity content. The principal limitation to the TFTR fusion power production was the disruptive stability limit. Secondary limitations were the confinement time, and limiter power handling capability.

Magnetohydrodynamic (MHD) activity within three zones (core, half-radius, and edge) of TFTR [Plasma Physics and Controlled Nuclear Fusion Research 1986 (IAEA, Vienna, 1987), Vol. 1, p. 51] tokamak plasmas are discussed. Near the core of the plasma column, sawteeth are often observed. Two types of sawteeth are studied in detail; one with complete, and the other with incomplete, magnetic reconnection. Their characteristics are determined by the shape of the q profile. Near the half-radius the m/n=3/2 and 2/1 resistive ballooning modes are found to correlate with a beta collapse. The pressure and the pressure gradient at the mode rational surface are found to play an important role in stability. MHD activity is also studied at the plasma edge during limiter H modes. The edge localized modes (ELM’s) are found to have a precursor mode with a frequency between 50–200 kHz and a mode number m/n=1/0. The mode does not show a ballooning structure. While these instabilities have been studied on many other machines, on TFTR the studies have been extended to high pressure (plasma pressure greater than 4×105 Pa) and low collisionality [vi*(a/2)<0.002, ve*(a/2)<0.01].

there have been at least three types of anomalous loss of alpha-like deuterium-deuterium (D-D) fusion products: (1) a magnetohydrodynamic (MHD)-induced loss ofD-D fusion products correlated with Mirnov and fishbone-type oscillations and sawtooth crashes, (2) a slow "delayed" loss of partially thermalized D-D fusion products occurring without large MHD activity, and (3) ion cyclotron resonance heating (lCRH)-induced loss of D-D fusion products ions observed during direct electron heating experiments, and possibly also during 3He minority heating. In this paper each of these will be reviewed, concentrating on those due to MHD activity, which are the largest of these anomalous losses. The experimental results are compared with numerical models of various fusion product transport mechanisms.