No abstract

Magnetoacoustic emission (MAE) and Barkhausen emission (BE) have been measured as a function of applied magnetic field and tensile stress from mild-steel samples in a wide range of heat treatments, to develop a technique to measure stress without prior knowledge of the microstructure. The results are supplemented by measurements of magnetic coercivity and mechanical hardness. MAE is found to decrease with increasing applied stress, whereas the variation of BE is more complicated. The amplitudes of both MAE and BE, as well as the coercivity and hardness are also found to depend on the microstructure to varying degrees. Thus in ferritic-pearlitic and ferritic-pearlitic-martensitic steel MAE is much more sensitive to stress than to changes in microstructure, whereas the sensitivity of BE to stress and microstructure is similar. Above 50 MPa MAE is also more sensitive to stress in ferrite containing cementite, whereas BE both lacks a monotonic dependence upon stress and is sensitive to microstructure. In martensite, however, there is no MAE, the BE increasing monotonically with stress. Tempered martensitic structures give a weak MAE signal that is more sensitive to tempering temperature than applied stress, whereas the BE increases with stress for tempers below 500°C and decreases above. The dependence of MAE and BE on magnetic field are discussed in terms of domain-wall nucleation and irreversible motion in ferrite at higher fields, and irreversible wall motion through martensite or pearlite at lower fields. The results imply that MAE can be used alone to measure stress provided the general form of the microstructure is known; otherwise BE can be used as an additional technique to resolve any ambiguity.

No abstract

No abstract

No abstract

Magnetoacoustic emission (MAE) and Barkhausen emission (BE) have been studied in ferromagnetic materials placed in a magnetic field, varying at a few millihertz. Comparison of the two signals indicates the nature of the domain walls responsible for the activity at a given field strength. In order to characterize a specimen the strength of the emission around the hysteresis loop is measured. The technique has been used to measure non-destructively the effects of the following. ( a ) Precipitates: both MAE and BE are sensitive to the growth of precipitates in Incoloy 904, and can be used to monitor the precipitate size. ( b ) Dislocations: BE and MAE exhibit high sensitivity to plastic deformation, and this has been studied in a-Fe. ( c ) Radiation: neutron irradiation of an Fe-Cu alloy produces small changes in emission, although with sufficient sensitivity for useful characterization of radiation effects. ( d ) Tensile stress: MAE is sensitive to stress over the whole range, but particularly at low stresses. Such measurements lay the foundation for the use of MAE for residual-stress measurements.

No abstract

No abstract