In this Technical Design Report (TDR) we describe the NEXT-100 detector that will search for neutrinoless double beta decay (β β 0ν) in 136 Xe at the Laboratorio Subterráneo de Canfranc (LSC), in Spain. The document formalizes the design presented in our Conceptual Design Report (CDR): an electroluminescence time projection chamber, with separate readout planes for calorimetry and tracking, located, respectively, behind cathode and anode. The detector is designed to hold a maximum of about 150 kg of xenon at 15 bar, or 100 kg at 10 bar. This option builds in the capability to increase the total isotope mass by 50% while keeping the operating pressure at a manageable level. The readout plane performing the energy measurement is composed of Hamamatsu R11410-10 photomultipliers, specially designed for operation in low-background, xenon-based detectors. Each individual PMT will be isolated from the gas by an individual, pressure resistant enclosure and will be coupled to the sensitive volume through a sapphire window. The tracking plane consists in an array of Hamamatsu S10362-11-050P MPPCs used as tracking pixels. They will be arranged in square boards holding 64 sensors (8 × 8) with a 1-cm pitch. The inner walls of the TPC, the sapphire windows and the boards holding the MPPCs will be coated with tetraphenyl butadiene (TPB), a wavelength shifter, to improve the light collection.

Although a great deal is known about design techniques for optimum (in a minimax error sense) finite impulse response (FIR) low‐pass digital filters, there have not been established any practical design rules for such filters. Thus, a user is unable to easily decide on the (approximate or exact) filter order required to meet his design specifications and must resort to tables or trial and error procedures. In this paper, such a set of design rules is given. In the case of very narrow bandwidth or very wide bandwidth filters, analytic relations between the filter parameters can be readily obtained. In all other cases, exceedingly good linear and nonlinear fits to the data can be obtained over somewhat restricted ranges of the parameters. These fitting procedures lead to a practical set of simple design rules for estimating filter order from the desired specifications.

No abstract

No abstract

Silicon photomultipliers (SiPM) are the photon detectors chosen for the tracking readout in NEXT, a neutrinoless β β decay experiment which uses a high pressure gaseous xenon time projection chamber (TPC). The reconstruction of event track and topology in this gaseous detector is a key handle for background rejection. Among the commercially available sensors that can be used for tracking, SiPMs offer important advantages, mainly high gain, ruggedness, cost-effectiveness and radio-purity. Their main drawback, however, is their non sensitivity in the emission spectrum of the xenon scintillation (peak at 175 nm). This is overcome by coating these sensors with the organic wavelength shifter tetraphenyl butadiene (TPB). In this paper we describe the protocol developed for coating the SiPMs with TPB and the measurements performed for characterizing the coatings as well as the performance of the coated sensors in the UV-VUV range.