The outermost layer of skin, stratum corneum (SC), functions as the major barrier to diffusion. SC has the architecture of dead keratin filled cells embedded in a lipid matrix. This work presents a detailed study of the hydration process in extracted SC lipids, isolated corneocytes and intact SC. Using isothermal sorption microcalorimetry and relaxation and wideline (1)H NMR, we study these systems at varying degrees of hydration/relative humidities (RH) at 25 degrees C. The basic findings are (i) there is a substantial swelling both of SC lipids, the corneocytes and the intact SC at high RH. At low RHs corneocytes take up more water than SC lipids do, while at high RHs swelling of SC lipids is more pronounced than that of corneocytes. (ii) Lipids in a fluid state are present in both extracted SC lipids and in the intact SC. (iii) The fraction of fluid lipids is lower at 1.4% water content than at 15% but remains virtually constant as the water content is further increased. (iv) Three exothermic phase transitions are detected in the SC lipids at RH=91-94%, and we speculate that the lipid re-organization is responsible for the hydration-induced variations in SC permeability. (v) The hydration causes swelling in the corneocytes, while it does not affect the mobility of solid components (keratin filaments).

The aggregation of the fluorescent hairy rod, anionic conjugated polyelectrolyte poly{1,4-phenylene-[9,9-bis(4-phenoxybutylsulfonate)]fluorene-2,7-diyl} (PBS-PFP) has been studied in aqueous solutions by molecular dynamics simulations, fluorescence and light scattering. Formation of clusters leads to considerable increases in light scattering, decreases in the fluorescence quantum yields and red shifts in emission maxima. Molecular dynamics simulations considering two isolated tetramers in aqueous solution show that they rapidly form aggregates, and support experimental evidence for the association of polymer chains involving both electrostatic and hydrophobic interactions. They also provide indications for proximity of aromatic rings, which is likely to be the main factor responsible for the observed fluorescence behaviour. However, there are no indications of extensive pi-stacking. The organic co-solvents methanol, acetonitrile and dioxane break up these aggregates. From studies of the dependence of the aggregation behaviour on dielectric constant or the empirical solvent parameters E(N)(T) and B(KT) for binary mixtures with water, it can be seen that this is not simply an effect of changing solvent polarity, but is due to preferential solvation of the polymer chains. This is supported by molecular dynamic simulations on two tetramers in water-dioxane mixtures (70:30%). It is suggested that similar factors are involved in both the association behaviour and aggregate disruption with other hairy rod conjugated polyelectrolytes in water.

Polymers are the most common excipients used in pharmaceutical dosage forms, and often new applications and innovative polymers appear aiming to overcome unmet needs in the drug formulation field. Orodispersible dosage forms based on polymeric matrices have currently demonstrated their prominence in accordance with the actual market requirements and patients' demands. The versatility of the polymeric oral films had proven their high value as suitable technological platforms for extension and adjustment to different delivery routes and promising markets. These are the main reasons for the increasing investment of several companies in this technology and their applicability in different therapeutic segments. This pharmaceutical form with a blustering beginning as a breath freshener had an emergent entrance in the Rx market proving its reliable value. This review describes and explores the oral film technology from its main component, the polymeric matrices, to the new and possible market applications, highlighting all the critical and important points of its development.

In the presence of the nonionic alkyloxyethylene surfactant n-dodecylpentaoxyethylene glycol ether (C 12 E 5 ), the anionic conjugated polyelectrolyte (CPE) poly{1,4-phenylene-[9,9-bis(4-phenoxy-butylsulfonate)]fluorene-2,7-diyl} (PBS-PFP) dissolves in water, leading to a blue shift in fluorescence and dramatic increases in fluorescence quantum yields above the surfactant critical micelle concentration (cmc). No significant changes were seen with a poly(ethylene oxide) of similar size to the surfactant headgroup, confirming that specific surfactant-polyelectrolyte interactions are important. From UV-visible and fluorescence spectroscopy, dynamic light scattering (DLS), small-angle X-ray scattering (SAXS), cryogenic transmission electron microscopy (cryo-TEM), and electrical conductivity, together with our published NMR and small-angle neutron scattering (SANS) results, we provide a coherent model for this behavior in terms of breakup of PBS-PFP clusters through polymer-surfactant association leading to cylindrical aggregates containing isolated polymer chains. This is supported by molecular dynamics simulations, which indicate stable polymer-surfactant structures and also provide indications of the tendency of C 12 E 5 to break up polymer clusters to form these mixed polymer-surfactant aggregates. Radial electron density profiles of the cylindrical cross section obtained from SAXS results reveal the internal structure of such inhomogeneous species. DLS and cryo-TEM results show that at higher surfactant concentrations the micelles start to grow, possibly partially due to formation of long, threadlike species. Other alkyloxyethylene surfactants, together with poly(propylene glycol) and hydrophobically modified poly(ethylene glycol), also solubilize this polymer in water, and it is suggested that this results from a balance between electrostatic (or ion-dipole), hydrophilic, and hydrophobic interactions. There is a small, but significant, dependence of the emission maximum on the local environment.

a b s t r a c tNovel chitosan based polyelectrolyte complexes (PEC) were developed and optimized in order to obtain films possessing the optimal functional properties (flexibility, resistance, water vapour transmission rate and bioadhesion) to be applied on skin. The development was based on the combination of chitosan and two polyacrylic acid (PAA) polymers with different crosslinkers and crosslinking densities. The interaction between the polymers was maximized controlling the pH, and by forming the films at a pH value close to the pK a of the respective components as identified by potentiometric and turbidimetric titrations. The action of glycerol, PEG200, Hydrovance and trehalose upon the functional properties of the films was also evaluated. Glycerol was found to improve the film properties in terms of flexibility, resistance and water vapour transmission rate (WVTR) with a maximum effect at 30%. The application of a pressure sensitive adhesive (PSA) significantly improved bioadhesion with a negligible influence in the resistance and flexibility of the films.The optimized film, including adhesive, has shown very good properties for application in the skin and represents a very promising formulation for further incorporation of drugs for topical and transdermal administration.

Understanding factors responsible for the fluorescence behavior of conjugated polyelectrolytes and modulation of their behavior are important for their application as functional materials. The interaction between the anionic poly{1,4-phenylene-[9,9-bis(4-phenoxy-butylsulfonate)]fluorene-2,7-diyl}copolymer (PBS-PFP) and cationic gemini surfactants R,ω-(C m H 2m+1 N + (CH 3 ) 2 ) 2 (CH 2 ) s (Br -) 2 (m-s-m; m ) 12, s ) 2, 3, 5, 6, 10, and 12) has been studied experimentally in aqueous solution. These surfactants are chosen to see whether molecular recognition and self-assembly occurs between the oppositely charged conjugated polyelectrolyte and gemini surfactant when the spacer length on the surfactant is similar to the intercharge separation on the polymer. Without surfactants, PBS-PFP exists as aggregates. These are broken up upon addition of gemini surfactants. However, as anticipated, the behavior strongly depends upon spacer length (s). Fluorescence measurements show three surfactant concentration regimes: At low concentrations (<2 × 10 -6 M) quenching occurs and is most marked with the small spacer 12-2-12; at intermediate concentrations (∼2 × 10 -6 -10 -3 M), fluorescence intensity is constant, with a 12-carbon spacer 12-12-12 showing the strongest fluorescence; above the critical micelle concentration (CMC; ∼10 -3 M) increases in emission intensity are seen in all cases and are largest with the intermediate spacers 12-5-12 and 12-6-12, where the spacer length most closely matches the distance between monomer units on the polymer. With longer spacer length surfactants, surface tension measurements for concentrations below the CMC reveal the presence of polymer-surfactant aggregates at the air-water interface, possibly reflecting increased hydrophobicity. Above the CMC, small-angle neutron scattering experiments for the 12-6-12 system show the presence of spherical aggregates, both for the pure surfactant and for polyelectrolyte/gemini mixtures. Molecular dynamics simulations help rationalize these observations and show that there is a very fine balance between electrostatic and hydrophobic interactions. With the shortest spacer 12-2-12, Coulombic interactions are dominant, while for the longest spacer 12-12-12 the driving force involves hydrophobic interactions. Qualitatively, with the intermediate 12-5-12 and 12-6-12 systems, the optimum balance is observed between Coulombic and hydrophobic interactions, explaining their strong fluorescence enhancement.

No abstract

In order to understand the human haptic system, the mechanical characterization of skin contact is an important task. As the skin constitutes itself a surface, it is convenient to describe the problem using a contacting surface analysis, especially concerning the friction which occurs when the skin interacts with other surfaces. Several published works have shown that the analysis of the friction response of the skin can provide an indirect way to assess the skin condition.The present study uses a new approach to evaluate in vivo the human friction measured by direct sliding action with an increase of the normal load. Two moisturizer ointments, petrolatum and glycerin, were applied in two anatomical sites of the individual submitted to this study. In order to evaluate hydration effects, this study also incorporates a direct characterization of the moisture content measuring the transepidermal water loss (TEWL).The effect of the moisturizers as a function of time after the application was studied for different anatomical sites. The normal compression and the tangential forces were measured using a three-dimensional force sensor while slipping the skin over a spherical glass surface. The skin hydration was concomitantly monitored by measuring the TEWL.