In this manuscript, the graphene oxide (GO) was modified by hyper-branched polyester (HBP). The effects of GO or modified GO (HBP-m-GO) on the mechanical performance and wearing properties were investigated. The results of X-ray photoelectron spectra (XPS), Fourier transform infrared spectroscopy (FT-IR), and transmission electron microscopy (TEM) revealed the successful grafting of HBP onto GO. The thermogravimetric analysis (TGA) indicated that the graft amount of HBP is calculated to be 9.6 wt%. The GO or HBP-m-GO was added into acrylonitrile-butadiene-styrene copolymer (ABS) to prepare the ABS/GO composites. The mechanical properties and wear performance of the composites were studied to comparatively study the impact of GO modification on the properties of the composites. The results revealed that the addition of GO has a significant effect on the mechanical properties of ABS, and when HBP-m-GO was added, the elastic modulus and tensile strength of ABS/HBP-m-GO increased evidently compared with ABS/GO. The tensile strength increased from 42.1 ± 0.6 MPa of pure ABS to 55.9 ± 0.9 MPa, up to 30%. Meanwhile, the elongation at break was significantly higher than ABS/GO to 20.1 ± 1.3%, slightly lower than that of pure ABS. For wear performance, the addition of raw GO decreased the friction coefficient, and when the HBP-m-GO was added, the friction coefficient of the ABS/HBP-m-GO dropped more evidently. Meanwhile, the weight loss during the wear test decreased evidently. The related mechanism was discussed.
Poly-L-lactic acid (PLLA) is an environmentally friendly and renewable polymer material with excellent prospects, but its low crystallization rate greatly limits its application. Through the amidation reaction between amino hyperbranched polymer (HBP N103) and carboxylated carbon nanotubes (CNTs), CNTs-N103 was obtained. The modification was confirmed by Fourier-transform infrared (FTIR) spectroscopy, X-ray electron spectroscopy (XPS) and thermogravimetric analysis (TGA). Using transmission electron microscopy (TEM), we observed the changes on the surface of modified CNTs. PLLA/CNT composites were prepared, and differential scanning calorimetry (DSC) was used to investigate the crystallization behavior of the composites. The results showed that the addition of CNTs could greatly improve the crystallization properties of PLLA; at the same concentration, the modified CNTs had better regulation ability in PLLA crystallization than the unmodified CNTs. Moreover, in the concentration range of 0.1–1%, with the increase in HBP concentration, the ability of CNTs-N103 to regulate the crystallization of PLLA increased as well. Wide-angle X-ray diffraction (WAXD) once again proved the improvement of the crystallization ability. The results of polarized optical microscopy (PLOM) showed that the number of nucleation points increased and the crystal became smaller.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.