In an attempt to improve the sensitivity of detection in capillary electrophoresis (CE), a novel online sample-concentration method, full-capillary sample stacking (FCSS)/sweeping-micellar electrokinetic chromatography (sweeping-MEKC) mode, is proposed. Naphthalene-2,3-dicarboxaldehyde (NDA)-derivatized tryptophan and isoleucine were selected as model compounds. In the initial step, the weakly acidic compounds, dissolved in a low-conductivity buffer (35.1 microS/cm; apparent ph (pH*) in a mixed solution of acetonitrile/methanol/water, 4.6), fill the entire capillary, two vials of a high-conductivity buffer (2.06 mS/cm; pH* 2.0) are placed on each end, and a negative polarity is then applied. Under these conditions, the direction of the electroosmotic flow (EOF) is toward the inlet. Meanwhile, the anionic analytes move in the reverse direction and are neutralized and stacked at the boundary of a dynamic pH-junction (between the sample matrix and the nonmicellar background solution (BGS)). When the sample concentration is completed, the BGS is quickly changed to solutions containing SDS-BGS for the subsequent separation. Since the mobility of SDS-analytes is then greater than the EOF, the following steps occur by the sweeping (for focusing) and MEKC (for separation) mode. Using these steps, a full-capillary sample injection/separation can be achieved.

The use of single capillaries (25 and 50 microm inner diameter (ID)) and coupled capillaries of different diameters (100-50 and 75-25 microm ID) based on micellar electrokinetic chromatography (MEKC) and sweeping-MEKC modes is compared and reported. Naphthalene-2,3-dicarboxaldehyde (NDA)-derivatized dopamine was selected as the model compound by examining the fluorescence intensity when a violet (410 +/- 7 nm, 2 mW) light-emitting-diode (LED) was used as the light source. When a single capillary (50 microm ID) was used, the detection limit for NDA-derivatized dopamine was determined to be 2.0 x 10(-7) M (Signal-to-nose ratio S/N = 3) based on the MEKC mode. This was improved to 4.0 x 10(-9) M when the sweeping-MEKC mode was applied. In addition, this can be further improved to 1.0 x 10(-9) M and 5.6 x 10(-10) M when 100-50 and 75-25 microm ID coupled capillaries are used. The use of the coupled capillary is also helpful for improving the separation efficiency. Based on the sweeping-MEKC mode, the number of theoretical plates (N) for the detected peaks were determined to be 6.3 +/- 2.7 x 10(5) by means of a single capillary (50 microm ID). This can be improved to 9.4 +/- 3.6 x 10(5) and 9.4 +/- 0.9 x 10(6) when the 100-50 and 75-25 microm ID coupled capillaries were applied.

A crystal violet (CV) standard was irradiated under a Hg-Cd lamp for different exposure times to obtain various N-demethylation products. CZE effectively separated the photodegradation products based on molecular weight differences. In contrast, micellar EKC (MEKC), using SDS as the surfactant, was ineffective because the binding constants of the demethylation products and SDS were too close for separation. Nevertheless, MEKC analysis of ink has applications in forensic science because MEKC separated neutral components in the inks. Thus, MEKC can be used to obtain an ink "fingerprint" since each ink is unique depending on the location and time it was made. In contrast, CZE is useful for dating inks because CV is the primary ink dye and it photodegrades slowly.

The application of an ultraviolet (UV) light-emitting diode (LED) to on-line sample concentration/fluorescence detection in capillary electrophoresis (CE) is described. The utility of a UV-LED (peak emission wavelength at 380 nm, ∼2 mW) for fluorescence detection was demonstrated by examining both a naturally fluorescent (riboflavin) compound and a nonfluorescent compound (tryptophan), respectively. The detection limit for riboflavin was determined to be 0.2 ppm by the normal MEKC mode, which was improved to 3 -7 ppb when dynamic pH-junction technique was applied. On the other hand, the detection limit of the tryptophan derivative was determined to be 1.5 ppm using the MEKC mode, which was improved to 3 ppb when the sweeping-MEKC mode was applied. In an analysis of an actual sample, the concentrations of riboflavin in beer, and tryptophan in urine and milk samples were determined, respectively.

The use of a low-temperature (0 degrees C) bath-assisted coupled capillary for the separation of naphthalene-2,3-dicarboxaldehyde (NDA)-derivatized dopamine and norepinephrine using the sweeping-micellar electrokinetic capillary chromatography (MEKC) mode is described. In this technique, a capillary consisting of two portions with different inside diameters is used. Therefore, the field strength inside the capillary is different. Hence, the electrophoretic migration velocities of the analytes and the electro-osmotic flow (EOF) also are different. Furthermore, when a portion of the capillary (wide portion, used for sweeping) is immersed in a low-temperature bath, the viscosity of the buffer and the retention factor of the analytes inside are increased. Thus, not only are the interactions between the SDS micelles and the analytes increased, but the SDS-analytes also move more slowly. As a result, a more complete separation can be achieved, even when the sample injection volume is large, up to approximately 2 microL. In general, when the volume of an injected sample is larger, the effects of sweeping and separation would become insufficient, especially when the retention values (k) of the analytes are quite different. However, this limitation can be improved when the low-temperature bath/coupled capillary/sweeping-MEKC mode is used.