Aligned carbon nanotubes with open ends have been fabricated on silicon wafer in one step using a microwave plasma enhanced chemical vapor deposition system with a mixture of methane and hydrogen as precursors. High concentration hydrogen plasma and high negative bias voltage to the substrate induce anisotropic etching of carbon nanotubes and can effectively reduce the randomly oriented carbon nanotubes. The mechanism of aligned carbon nanotubes with open ends is proposed in this letter.

No abstract

Tin (Sn) nanowires, with 15 and 60 nm average diameter and up to 10 µm in length, were fabricated by an injection process using a hydraulic pressure method. The Sn melt was injected into an anodic aluminium oxide (AAO) template and solidified to form nanowires. By back etching the aluminium substrate and barrier layer, the nanowire array ends were partially exposed from the bottom face of the AAO template. The filling ratio of nanowires inside and through the thickness of the AAO template was found to be close to 100%. The nanowires were also found to be dense and continuous with uniform diameter throughout their length. Transmission electron microscope (TEM) and x-ray diffraction (XRD) studies on the 60 nm diameter nanowires revealed that the nanowires were single crystals with body-centred-tetragonal (bct) structure predominantly growing along the [100] direction. The current method of synthesizing nanowires is straightforward, low-cost and suitable for low-melting point (<650 °C) metals including low-melting point alloys with stoichiometric composition.

Carbon-fiber (CF)-reinforced aluminum-matrix composites were prepared by spreading fibers and squeeze casting. The interface structure of CF/Al composites was examined using high-resolution transmission electron microscopy (HRTEM) and electron spectroscopy for chemical analysis (ESCA). Aluminum carbide (Al 4 C 3 ) interfacial reaction products were observed to nucleate heterogeneously from carbon fibers and to grow toward the aluminum matrix in the form of lath-like crystals after heat treatment. The growth of aluminum carbide was anisotropic, since it was faster along the a-and b-axes of the basal plane than along the c-axis. Both the tensile strength and the elongation of composites decline with an increased duration of heat treatment. The results of ESCA revealed that approximately 1 pct of carbide enhanced interface bonding. However, increasing the content of brittle carbides to over 3 pct after heat treatment degraded the mechanical properties of composites.

No abstract

No abstract

No abstract

No abstract