This paper presents the Integrated Nowcasting through Comprehensive Analysis (INCA) system, which has been developed for use in mountainous terrain. Analysis and nowcasting fields include temperature, humidity, wind, precipitation amount, precipitation type, cloudiness, and global radiation. The analysis part of the system combines surface station data with remote sensing data in such a way that the observations at the station locations are reproduced, whereas the remote sensing data provide the spatial structure for the interpolation. The nowcasting part employs classical correlation-based motion vectors derived from previous consecutive analyses. In the case of precipitation the nowcast includes an intensity-dependent elevation effect. After 2-6 h of forecast time the nowcast is merged into an NWP forecast provided by a limited-area model, using a predefined temporal weighting function. Cross validation of the analysis and verification of the nowcast are performed. Analysis quality is high for temperature, but comparatively low for wind and precipitation, because of the limited representativeness of station data in mountainous terrain, which can be only partially compensated by the analysis algorithm. Significant added value of the system compared to the NWP forecast is found in the first few hours of the nowcast. At longer lead times the effects of the latest observations becomes small, but in the case of temperature the downscaling of the NWP forecast within the INCA system continues to provide some improvement compared to the direct NWP output.

Abstract. The ALADIN System is a numerical weather prediction (NWP) system developed by the international AL-ADIN consortium for operational weather forecasting and research purposes. It is based on a code that is shared with the global model IFS of the ECMWF and the ARPEGE model of Météo-France. Today, this system can be used to provide a multitude of high-resolution limited-area model (LAM) configurations. A few configurations are thoroughly validated and prepared to be used for the operational weather forecasting in the 16 partner institutes of this consortium. These configurations are called the ALADIN canonical model configurations (CMCs). There are currently three CMCs: the AL-ADIN baseline CMC, the AROME CMC and the ALARO CMC. Other configurations are possible for research, such as process studies and climate simulations.The purpose of this paper is (i) to define the ALADIN System in relation to the global counterparts IFS and ARPEGE, (ii) to explain the notion of the CMCs, (iii) to document their most recent versions, and (iv) to illustrate the process of the validation and the porting of these configurations to the operational forecast suites of the partner institutes of the AL-ADIN consortium. This paper is restricted to the forecast model only; data assimilation techniques and postprocessing techniques are part of the ALADIN System but they are not discussed here.

No abstract

Abstract. The 2.5 km convection-permitting (CP) ensemble AROME-EPS (Applications of Research to Operations at Mesoscale -Ensemble Prediction System) is evaluated by comparison with the regional 11 km ensemble ALADIN-LAEF (Aire Limitée Adaption dynamique Développement InterNational -Limited Area Ensemble Forecasting) to show whether a benefit is provided by a CP EPS. The evaluation focuses on the abilities of the ensembles to quantitatively predict precipitation during a 3-month convective summer period over areas consisting of mountains and lowlands. The statistical verification uses surface observations and 1 km × 1 km precipitation analyses, and the verification scores involve state-of-the-art statistical measures for deterministic and probabilistic forecasts as well as novel spatial verification methods. The results show that the convectionpermitting ensemble with higher-resolution AROME-EPS outperforms its mesoscale counterpart ALADIN-LAEF for precipitation forecasts. The positive impact is larger for the mountainous areas than for the lowlands. In particular, the diurnal precipitation cycle is improved in AROME-EPS, which leads to a significant improvement of scores at the concerned times of day (up to approximately one-third of the scored verification measure). Moreover, there are advantages for higher precipitation thresholds at small spatial scales, which are due to the improved simulation of the spatial structure of precipitation.

Although the quality of numerical ensemble prediction systems (EPS) has greatly improved during the last few years, these systems still show systematic deficiencies. Specifically, they are underdispersive and lack both reliability and sharpness. A variety of statistical postprocessing methods allows for improving direct model output. Since 2007, Aire Limité e Adaptation Dynamique Dé veloppement International Limited Area Ensemble Forecasting (ALADIN-LAEF) has been in operation at the Central Institute for Meteorology and Geodynamics (ZAMG), and its 2-m temperature model output subject to calibration. This work follows the approach of nonhomogeneous Gaussian regression (NGR) that addresses a statistical correction of the first and second moment (mean bias and dispersion) for Gaussian-distributed continuous variables. It is based on the multiple linear regression technique and provides a predictive probability density function (PDF) in terms of a normal distribution. Fitting the regression coefficients, a minimum continuous ranked probability score (CRPS) estimation has been chosen instead of the more traditional maximum likelihood technique. The use of high-resolution analysis data on a 1 km 3 1 km grid as training data improves the forecast skill in terms of CRPS by about 35%, especially on the local scale. The percentage of outliers decreases significantly without loss of sharpness. Sensitivity studies confirm that about half of the total improvement can be attributed to the effect of a bias correction. The training length plays a minor role, at least for the chosen verification period. A rescaling of the predictive PDF is important in order to obtain sharp forecasts, especially in the short range. Applying the same method to the global ensemble from the European Centre for Medium-Range Weather Forecasts (ECMWF) gives improvements of similar magnitude. However, the calibrated 2-m temperature of ALADIN-LAEF still remains slightly better than the 2-m temperature from calibrated ECMWF-EPS, which leads to the conclusion that statistical downscaling of EPS cannot replace dynamical downscaling. Finally, an advanced version of NGR, the so-called NGR-TD, which uses timeweighted averaging within minimum CRPS estimation, is able to yield a further improvement of about 5% in terms of the CRPS.

The lack or inadequate representation of uncertainties in the surface initial conditions (ICs) affects the quality of ensemble forecast, in particular the near surface temperature and precipitation. In this paper, a strategy for perturbing surface ICs in limited area model ensemble prediction system, noncycling surface breeding (NCSB) is proposed. The strategy combines short-range surface forecasts driven by perturbed atmospheric forcing and the breeding method for generating the perturbation to surface ICs. NCSB is implemented and tested in Aire Limitée Adaptation dynamique Développement InterNational-limited area ensemble forecasting (ALADIN-LAEF). Statistical verification demonstrates that the application of NCSB improves the ALADIN-LAEF 2m temperature and precipitation forecast. Positive impacts are also obtained for temperature and specific humidity in the lower atmosphere.

Abstract. A modification of the widely used SPPT (Stochastically Perturbed Parametrisation Tendencies) scheme is proposed and tested in a Convection-permitting – Limited Area Ensemble Forecasting system (C-LAEF) developed at ZAMG (Zentralanstalt für Meteorologie und Geodynamik). The tendencies from four physical parametrization schemes are perturbed: radiation, shallow convection, turbulence, and microphysics. Whereas in SPPT the total model tendencies are perturbed, in the present approach (pSPPT hereinafter) the partial tendencies of the physics parametrization schemes are sequentially perturbed. Thus, in pSPPT an interaction between the uncertainties of the different physics parametrization schemes is sustained and a more physically consistent relationship between the processes is kept. Two configurations of pSPPT are evaluated over two separate months (one in summer and another in winter). Both schemes increase the stability of the model and lead to statistically significant improvements in the probabilistic performance compared to a reference run without stochastic physics. An evaluation of selected test cases shows that the positive effect of stochastic physics is much more pronounced on days with high convective activity. Small discrepancies in the humidity analysis can be dedicated to the use of a very simple supersaturation adjustment. This and other adjustments are discussed to provide some suggestions for future investigations.

Model error in ensemble prediction systems is often represented by either a tendency perturbation approach or a process-based parameter perturbation scheme. In this paper a novel hybrid stochastically perturbed parameterization (HSPP) scheme is proposed and implemented in the Convection Permitting Limited Area Ensemble Forecasting (C-LAEF) system developed at the Zentralanstalt für Meteorologie und Geodynamik (ZAMG). In HSPP, the individual parameterization tendencies of the physical processes radiation, shallow convection, and microphysics are perturbed stochastically by a spatially and temporally varying pattern. Uncertainties in the turbulence scheme are considered by perturbing key parameters on the process level. The proposed scheme HSPP features several advantages compared to the popular stochastically perturbed parameterization tendencies (SPPT) scheme: it considers a more physically consistent relationship between different parameterization schemes, deals with uncertainties especially adapted to the individual physical processes, respects conservation laws of energy and moisture, and eliminates the tapering function that has to be introduced to the SPPT scheme because of mainly numerical reasons. The hybrid scheme HSPP is evaluated over one summer and one winter month and compared to a reference ensemble without any stochastic physics perturbations and to two versions of the SPPT scheme. The results show that HSPP significantly increases the ensemble spread of temperature, humidity, wind speed, and pressure, especially in the lower levels of the atmosphere where a tapering function is active in the original SPPT approach. Precipitation verification yields a generally improved probabilistic performance of the HSPP scheme in summer when convection is dominating, which has also been demonstrated in a case study.