Background To assess changes of the craniocervical junction (CCJ), computed tomography (CT) is considered the reference standard. Recent advances in bone depiction on magnetic resonance imaging (MRI) enable high‐quality visualization of osseous structures. Consequently, MRI may serve as an alternative to CT, without the use of ionizing radiation. Purpose To compare two MRI sequences optimized for bone visualization to the CT reference standard in the assessment of the osseous CCJ. Study Type Prospective. Population/Subjects Twenty‐seven decedents and five healthy volunteers. Field Strength/Sequence 3T/ultrashort‐echo time gradient echo (UTE) and optimized 3D‐multiecho in‐phase gradient echo sequences (FRACTURE). Assessment All decedents were scanned with both MRI sequences and CT. Three observers rated degeneration to obtain a score for the upper (atlanto‐dental and left/right atlanto‐occipital joint) and for the lower part of the CCJ (left and right atlanto‐axial joint). Two reader rated the following quantitative parameters: basion‐axial‐interval, atlanto‐dental‐interval, atlanto‐occipital‐interval, Powers‐ratio, and signal/contrast‐to‐noise‐ratio. As a proof of concept, five healthy volunteers were scanned with both MRI sequences. Statistical Tests Degeneration was assessed on a Likert scale by three independent observers. Interrater and intermodality reliability were calculated using an intraclass correlation coefficient. To compare distance measurements between examination methods, a Friedman test, between‐degenerative ratings, and a Kruskal–Wallis test were performed. Results Degenerative ratings of the CCJ between MRI sequences and CT showed a good interrater and intermodality agreement. MRI sequences tended to underestimate the degree of degeneration compared to CT, and this became more marked with increasing degeneration severity. There were no significant relationships between distance measurements and the degree of degeneration (PCT = 0.62, PUTE = 0.64, PFRACTURE = 0.67). The in vivo examination proved the feasibility of both MRI methods in a clinical setting. Data Conclusion Quantitative and qualitative ratings on MR images were comparable to CT images; thus, MRI may be a valid alternative to CT assessing the CCJ. Level of Evidence 1. Technical Efficacy Stage 3.

Background: The treatment of unstable (Neer type IIB and V) extra-articular distal clavicle fractures remains challenging, especially when encountering a small lateral fragment which does not allow for sufficient screw purchase. It was the purpose of this study to present the clinical and radiologic outcome of a consecutive series of patients treated by a stand-alone coracoclavicular stabilization using a so-called cow-hitch technique with a suture anchor. Methods: Nineteen patients were treated with a specific surgical technique for distal clavicle fractures (11 left, 8 right) with either rupture or bony avulsion of the coracoclavicular ligaments. Fourteen patients were examined in our outpatient clinic for the purpose of this study after a mean follow-up of 5 years (1-12.2 years). The examination included scoring according to Constant Murley score (CMS), the American Shoulder and Elbow Surgeons Standardized Shoulder Assessment Form (ASES), the Subjective Shoulder Value (SSV), and follow-up radiographs. Two additional patients were amenable to a telephone interview. Results: All patients reported very good subjective results, with a mean SSV of 92% and a mean ASES score of 96%. The CMS resulted in average absolute values of 92 points. Fractures consolidated in 95% of cases. One patient developed an asymptomatic pseudarthrosis. The coracoclavicular distance was restored from 21 mm preoperatively to 11 mm at the final follow-up and finally showed an average side-to-side difference of þ1.8 mm. Sports activities were fully resumed after an average of 4.7 months. Conclusion:The coracoclavicular stand-alone cow-hitch suture repair for unstable distal clavicle fractures is a minimally invasive fixation technique without prominent hardware that allows for an anatomic reduction and stable fixation with a low complication and high bony union rate. Both radiographic and clinical long-term results are very satisfactory.

Background: Metallic implants show dose-modulating effects in radiotherapy and complicate its computed tomography (CT)-based planning. Dose deviations might not only affect the surrounding tissues due to backscattering and inadvertent dose increase but might also compromise the therapeutic effect to the target lesion due to beam attenuation. Later on, follow-up imaging is often obscured by metallic artefacts. Purposes: This study investigates the dosimetric impact of titanium and radiolucent carbon fiber/polyether ether ketone (CF/PEEK) implants during adjuvant radiation therapy in long bones. (1) Does the use of CF/PEEK implants allow for a more homogenous application of radiation? (2) Is the dose delivery to the target volume more efficient when using CF/PEEK implants? (3) Do CF/PEEK implants facilitate CT-based radiation therapy planning? Materials and methods: After CT-based planning, bone models of six ovine femora were irradiated within a water phantom in two immersion depths to simulate different soft-tissue envelopes. Plates and intramedullary nails of both titanium and CF/PEEK were investigated. Radiation dosage and distribution patterns were mapped using dosimetry films. Results: First, the planned implant-related beam attenuation was lower for the CF/PEEK plate (1% vs. 5%) and the CF/PEEK nail (2% vs. 9%) than for corresponding titanium implants. Secondly, the effective decrease of radiation dosage behind the implants was noticeably smaller when using CF/PEEK implants. The radiation dose was not significantly affected by the amount of surrounding soft tissues. A significant imaging artefact reduction was seen in all CF/PEEK models. Conclusion: CF/PEEK implants lead to a more reliable and more effective delivery of radiation dose to an osseous target volume. With regard to radiation therapy, the use of CF/PEEK implants appears to be particularly beneficial for intramedullary nails.

Background The need for coracoclavicular (CC) stabilization in the fixation of fractures with CC instability (Neer type IIB and V) was biomechanically demonstrated by higher construct strength than isolated locking plate osteosynthesis. It was the purpose of this study to prove noninferiority of the new cow-hitch suture repair technique compared with the well-established suture tape double-button fixation with regard to overall fixation strength and cyclic loading properties. Methods Twelve human cadaver shoulders (7 right and 5 left) were matched for sex and age (mean age: 75 ± 5 years). An oblique parasagittal fracture line 20 mm medial to the acromioclavicular joint line was created, and the CC ligaments were dissected. Six shoulders were reconstructed by a double FiberTape fixation with two suture buttons (group DB), and the remaining six shoulders by a cow-hitch suture repair using a double FiberWire with only coracoid button fixation (group CH). Both reconstruction techniques were tested in a servo-hydraulic material testing machine for cyclic displacement (mm), stiffness (N/mm), and maximum load-to-failure (N) after 500 cycles at 3 mm/s and inferosuperior load between 15 and 70 N. Superior fragment displacement in space was recorded using a MicroScribe digitizer. Results There were no statistically significant differences regarding cyclic displacement (group DB: 0.7 mm; group CH: 1.3 mm; P = .36), stiffness (group DB: 177 N/mm; group CH: 116 N/mm; P = .17), maximum load-to-failure (group DB: 560 N; group CH: 492 N; P = .59), and superior displacement in space of the medial fragment (group DB: 3.2 mm; group CH: 1.6 mm; P = .48). Conclusion Fixation of unstable distal clavicle fractures using a double FiberWire cow-hitch suture repair with isolated coracoid button fixation for stand-alone CC stabilization resulted in similar biomechanical properties to a double-suture button fixation with FiberTapes while avoiding prominent clavicular implants.

Background: Predictive factors influencing outcomes after surgical fixation of osteochondral fractures (OCFs) in the knee, particularly time between injury and surgery, have not been determined. Purpose: To report imaging and clinical outcomes after OCF fixation and to assess the association between clinical scores and patient characteristics, lesion morphology, and appearance on magnetic resonance imaging (MRI) scans. Study Design: Case series; Level of evidence, 4. Methods: We assessed the clinical and imaging outcomes of 19 patients after screw fixation for OCFs in the knee at a minimum follow-up of 1 year. Patient characteristics, lesion morphology, and time from trauma to surgery were reviewed for each patient. At final follow-up, patients completed a 100-point visual analog scale (VAS) for pain, Tegner activity scale, Knee injury and Osteoarthritis Outcome Score (KOOS), and patient satisfaction survey. Postoperative MRI scans were assessed using the MOCART (magnetic resonance observation of cartilage repair tissue), Osteochondral Allograft MRI Scoring System, and bone marrow edema (BME) size. Results: The mean patient age at surgery was 21.3 ± 11.4 years, and the median time from trauma to surgery was 10 days (range, 0-143 days). The refixed OCF fragment failed in 1 (5.3%) patient on the lateral condyle at 15 months postoperatively. The mean follow-up for the remaining 18 patients was 4.7 ± 3.2 years, and postoperative outcomes were as follows: VAS pain score, 9.5 ± 17.9; Tegner score, 4.8 ± 2.3; KOOS–Pain, 85.9 ± 17.6, KOOS-Symptoms, 76.4 ± 16.1; KOOS–Activities of Daily Living, 90.3 ± 19.0; KOOS–Sport, 74.4 ± 25.4; and KOOS–Quality of Life, 55.9 ± 24.7. Overall, 84.2% were satisfied or very satisfied with outcomes. Patient age was significantly associated with KOOS subscale scores and subchondral imaging parameters including BME and presence of subchondral cysts, which in turn were the only imaging variables linked to clinical outcomes ( P < .05). Time from injury to surgery was not correlated with clinical or imaging outcomes. Conclusion: Fixation of OCFs yielded acceptable clinical and imaging outcomes at a mean 5-year follow-up with seemingly little influence of delayed surgical treatment. Postoperative subchondral changes were significantly associated with clinical outcomes and were linked to patient age at surgery.

Purpose To evaluate the added value of ultra-short echo time (UTE) and fast field echo resembling a CT using restricted echo-spacing (FRACTURE) MR sequences in the assessment of the osseous cervical spine using CT as reference. Materials and methods Twenty-seven subjects underwent postmortem CT and MRI within 48 h. Datasets were anonymized and analyzed retrospectively by two radiologists. Morphological cervical spine alterations were rated on CT, UTE and FRACTURE images. Afterward, neural foraminal stenosis was graded on standard MR and again after viewing additional UTE/FRACTURE sequences. To evaluate interreader and intermodality reliability, intra-class correlation coefficients (ICC) and for stenosis grading Wilcoxon-matched-pairs testing with multiple comparison correction were calculated. Results Moderate interreader reliability (ICC = 0.48–0.71) was observed concerning morphological findings on all modalities. Intermodality reliability was good between modalities regarding degenerative vertebral and joint alterations (ICC = 0.69–0.91). Compared to CT neural stenosis grades were more often considered as nonsignificant on all analyzed MR sequences. Neural stenosis grading scores differed also significantly between specific bone imaging sequences, UTE and FRACTURE, to standard MR sequences. However, no significant difference was observed between UTE and FRACTURE sequences. Conclusion Compared to CT as reference, UTE or FRACTURE sequence added to standard MR sequences can deliver comparable information on osseous cervical spine status. Both led to changes in clinically significant stenosis gradings when added to standard MR, mainly reducing the severity of neural foramina stenosis.

No abstract

No abstract